A Test for Rapid Tribological Characterization of Bearing Steels
Journal Title: Analele Universitatii "Dunarea de Jos" din Galati. Fascicula IX, Metalurgie si Stiinta Materialelor - Year 2012, Vol 35, Issue 1
Abstract
In this paper is a study the influence of the material and heat treatment on the changes of the fine structure parameters of the superficial layer of triboelements during the first cycles of rolling contact process. The tests were conducted by using a four-roller testing machine. The specimens (rollers) were made of case-hardening, through hardening and high frequency hardening steels. In order to induce different stress distributions in the superficial layer of the specimen specific treatments were applied. Using X-ray diffractometry can be appreciated that the durability of rolling tribosystems can be determined by an optimal relationship between studied parameters. The observed correlation can be used as a fast method to estimate the fatigue life of rolling bearing materials.
Authors and Affiliations
Constantin GHEORGHIES, Mihaela BUCIUMEANU, Dan SCARPETE, Livia GHEORGHIES, Dorian BOLD
Keywords
Related Articles
- EP ID EP623786
- DOI -
- Views 74
- Downloads 0
Performing System for Purifying Waste Water
Status of water pollution can be controlled and reduced. For this purpose it uses two types of processes, applied more or less consistently by the management and technical design. The first group of processes is characte...
Nanostructured SiC-Ni Composite Coatings Obtained By Electrodeposition – A Tribocorrosion Study
The tribocorrosion properties of SiC (20nm) - Ni nanostructured coatings have been studied in pin on disc tribocorrosimeter connected with an electrochemical cell. The objectives of our study in principal is to fully und...
The Influence of the Heat Treatment upon the Resistance to Corrosion of the Composite Obtained Using the Electrodepositing of TiO2 in a Nickel Matrix
The resistance to corrosion of a composite material obtained using the electrodepositing of TiO2 in a nickel matrix subjected to heat treatment was studied using the galvanostatic method; the samples were obtained by the...
Laser Deposition of Bronze Aluminum on Steel Support
In order to rise the wear and corrosion resistance of 0.45% C superficial steel layers, a multilayer coating was tested by injection of powder with 88.3% Cu; 9.5% Al; 2.2% Fe in melted bath by CO2 continuous wave laser....
Alumina Powder Properties Obtained by Neutralization Process of Sodium Aluminate
Today, the most production of alumina is used for aluminum production [1, 2] (metallurgy alumina), minor production of alumina is used for special purpose, as fire-resistant materials, electro porcelain and etc., and bec...