Pulsating Torque & Electromagnetic Field Analysis for Induction Machine using ANSYS simulation
Journal Title: International Journal of Engineering and Techniques - Year 2015, Vol 1, Issue 4
Abstract
This paper describes an electromagnetic field analysis of the induction machine and pulsating torque .Analyzed machine is three phase induction machine with squirrel cage. Fourier transform is used for the high harmonic components evaluation of the pulsating torque and the magnetic flux density along the air gap. The comparison between computed and measured torque is presented in conclusion. The electromagnetic field analysis is done by the ANSYS simulation. Fourier transform is used for the high harmonic components evaluation of the pulsating torque. The comparison between computed and measured torque is presented in conclusion. Whole experimental measurement was made with measurement card NI PCIe-6361 and shaft DATAFLEX22/20.
Authors and Affiliations
Keywords
Related Articles
- EP ID EP354922
- DOI -
- Views 93
- Downloads 0
Provide Practical Security Mechanism to Wireless Sensor Networks Using Modified Motesec Protocol
Wireless Sensor Network (WSN) is a promising field for research. As the use of this field increases, it is required to give proper security to this field. So to ensure the security of communication of data or messages an...
Pulsating Torque & Electromagnetic Field Analysis for Induction Machine using ANSYS simulation
This paper describes an electromagnetic field analysis of the induction machine and pulsating torque .Analyzed machine is three phase induction machine with squirrel cage. Fourier transform is used for the high harmonic...
Dynamic Power reduction of synchronous digital design by using of efficient clock gating technique
Clock gating is an effective method of reducing the dynamic power consumption in synchronous circuits. One of the ways to achieve this is by masking the clock that goes to the idle portion of the circuit. In This paper w...
Hardware Realization of interfaces in Wireless Sensor Node Implementation on FPGA
This paper presents interfaces required in wireless sensor node (WSN) implementation. Here keyboard, LCD, ADC and Wi-Fi module interfaces are presented. These interfaces are developed as hardware prototypes in the applic...
Kinematic Control of Pick and Place Robot Arm
The robot arm is widely used in many industries and dangerous areas. Automatic control of the robotic manipulator involves study of kinematic. The kinematic problem is defined as the transformation from the Cartesian spa...