Relay adjusting of output tension of autonomous source of power supply for gas-transport networks
Journal Title: Вісник Національного технічного університету "ХПІ". Серія: Проблеми удосконалювання електричних машин і апаратів. Теорія і практика - Year 2015, Vol 13, Issue 1122
Abstract
The system of the relay adjusting of autonomous source of power supply is presented for gas-transport networks. The calculation chart of the system of automatic control is made, dependence of frequency of switching of relay regulator is determined depending on the coefficient of loading.
Authors and Affiliations
A. N. Moiseiev, V. V. Voinov
Keywords
Related Articles
- EP ID EP408791
- DOI -
- Views 117
- Downloads 0
On the question of the classification of the voltage relay for the protection of domestic single-phase consumers from unacceptable voltage fluctuations in the mains
A classification of voltage-sensitive relays for protection of one-phase residential electrical customers against prohibitive voltage deviation in the supply main is presented. Main indications of voltage-sensitive relay...
The main relationships for calculations in two-circuits resonant amplifier of the electric power
Based on a Tesla transformer and an idealized circuit of two consecutive reactive active inductively coupled circuits with zero active resistance of the secondary circuit, a scheme of a resonant electric power amplifier...
Simulation of control axial flux permanent magnet generator
This article gives analysis and comparison of control system and stabilization external characteristic of axial flux generator. A technical solution is proposed that allow to control and stabilize external characteristic...
Features reversible thyristor contactless synchronous rectifier machines depending on the control angle
Techniques for calculating the characteristics of reversible thyristor rectifier for contactless synchronous machines, depending on the angle of thyristor control, are presented. Calculation of the protective circuits of...
Analysis of the thermal state of various modifications of the mining traction motor DC type ДТН-45/27
Purpose. Studies were made of the possibilities of increasing the hourly power of traction motors of direct current type ДТН-45/27. Methodology. Physical simulation of the DC motor was made to determine the influence of...