Research in Industrial Trials to Improve Trough-Thickness Z35 Properties of Hot Rolled Heavy Plates up to 60 mm Thickness for Structural Steels
Journal Title: Analele Universitatii "Dunarea de Jos" din Galati. Fascicula IX, Metalurgie si Stiinta Materialelor - Year 2016, Vol 39, Issue 2
Abstract
The main purpose of this industrial experimental rolling, done in ArcelorMittal Galati in the Heavy Plate Mill is to check the correlation between mechanical properties and the microstructure of chemical compositions used in trial in order to reach through-thickness Z properties. First chemical composition is C_Mn steel with mechanical properties designed to reach at least 275 MPa on yield strength. The other chemical composition is based on Nb and Ti alloying elements with mechanical properties designed to be equal or higher than 360 MPa. In total, four slabs with 250 mm thickness were rolled. Two slabs with targeted plates thickness of 22.5 mm and 60 mm were used in trial per each chemical composition in order to check the thickness feasibility of targeted through-thickness Z properties.
Authors and Affiliations
Costel DURDUC, Liviu GURĂU, Elena DRUGESCU, Viorica MUȘAT
Keywords
Related Articles
- EP ID EP577267
- DOI -
- Views 98
- Downloads 0
Severe Plastic Deformation an Advanced Method for Nanostructuring Shape Memory Alloys
Severe plastic deformation (SPD) is an advanced plastic deformation. In this process nanostructuring metals and alloys may be produced. Nanostructured shape memory alloys are associate with a very high strength, toughnes...
Sulphate Reducing Bacteria in Biofilms on Thermosetting Polymers/Zn Composite Layers
Bacterial adhesion to surfaces is the first step in the formation of a biofilm and has been studied extensively over the past decades in many diverse applications. Sulphate Reducing Bacteria (SRB) is a group of phylogene...
Influence of Atmospheric Conditions on the Mechanical Properties of Pet Rubber Composites
The aim of paper is to study the influence of environmental open air conditions on the PET-rubber composites. Two set of samples (Type I, Type II) were obtained with the same composition, but the composites of Type I are...
Variation of Mechanical Characteristics for Thin Wall Tubes Processed in Ultrasonic Field
The paper presents the variation of mechanical characteristics of resistance and plasticity for thin wall tubes made of stainless steel 10TiNiCr180, processed in ultrasonic field. Decrease of mechanical characteristics o...
Some Results of Researches to Develop the Proper Recycling Methods of Technological Residues from Secondary Aluminum Industry
The objective of the research is to identify new suitable process to use residual waste (like aluminium secondary dross, salt slag or fly ashes) in concrete products according with sustainable industry concepts. The pape...