Research Issues in DFIG Based Wind Energy System
Journal Title: Elektronika - Year 2018, Vol 22, Issue 1
Abstract
Among different renewable energy sources, Wind energy is the most imperative energy source in power system. The development of grid connected wind energy conversion system expands, its grid connectivity issues has additionally been expanded. A portion of the issues are incorporates, for example, the regulation of voltage at Point of Common Coupling (PCC), reactive power absorption and injection, voltage sag and swell and etc. The Doubly Fed Induction Generator (DFIG) is most broadly utilized as a part of wind energy conversion system. DFIGs are extremely sensitive to grid voltage disturbances. With expanded entrance of wind energy as a renewable energy source the wind turbine should be connected to the grid during transient conditions like grid faults. The Fault Ride-Through (FRT) or Low Voltage Ride Through (LVRT) capability of wind turbines during grid faults is one of the core requirements to ensure stability in the power grid during transients and fault conditions. In this paper consists of various grid connectivity issues and research areas of wind energy conversion system and also the various control schemes for improving the LVRT system. These several techniques are used to improve the LVRT capability and limit the fault current to avoid the disconnection of DFIG from the grid under fault conditions for enhancement of stability and the performance of wind turbine.
Authors and Affiliations
R. Rajasekaran, M. Mekala
Keywords
Related Articles
- EP ID EP368193
- DOI 10.7251/ELS1822040R
- Views 84
- Downloads 0
LUT Based Generalized Parallel Counters for State-of-art FPGAs
Generalized Parallel Counters (GPCs) are frequently used in constructing high speed compressor trees. Previous work has focused on achieving efficient mapping of GPCs on FPGAs by using a combination of general Look-up ta...
Prototype of the Multichannel Acquisition System Developed for ICTM Pressure Transmitters
This paper presents a prototype of the multichannel acquisition unit AKV-100 developed for purposes of pressure and temperature measurements using proprietary ICTM pressure transmitters TPa-110 based on MEMS piezoresisti...
Study on a Composite Patch Antenna Based on Left Handed Material with Near Zero Index
In this paper, a composite patch antenna based on left handed material (LHM) with near zero index (NZI) is presented. This composite patch antenna is designed by assembling split resonant rings (SRRs) and metal strips on...
Solar Cybertech: A Competition of Digitally Controlled Vehicles Poweredby Solar Panels
Solar Cybertech is a conquest/subject at Universidad Politecnica de Madrid where student teams deal with electronics and renewable energies. The conquest is based in the design and construction of a vehicle powered by so...
Design and Implementation of a Novel Directional Coupler for UHF RFID Reader
The directional coupler is applied to isolating RX from TX because of low cost and simplicity compared to the circulator in the radio-frequency identification (RFID) reader. Because of unequal phase velocity between odd...