Research of dependence of electrodynamic characteristics of the crack which have been cut in the rectangular wave guide, from change of its sizes and position
Journal Title: Вісник Житомирського державного технологічного університету. Серія: Технічні науки - Year 2017, Vol 79, Issue 1
Abstract
Electrodynamic characteristics of the crack which have been cut in a wide wall of a rectangular wave guide are investigated. In resonant and non-resonant wave guide slot-hole aerials, one of the reasons of loss of capacity of a signal is a mismatch of entrance resistance of cracks with wave resistance of a wave guide. Possibility of reduction of influence of the specified lack by change of electrodynamic characteristics of a crack is offered. By a technique outlined in [1] dependency diagrams of active сonductivity crack radiations in a wave guide and from a wave guide, jet conductivity and factor of reflexion of a crack from its arrangement, the geometrical sizes and change of working length of a wave are constructed. The analysis of the received results from the point of view of possibility of maintenance of reduction of losses of capacity of a signal of a wave guide slot-hole radiator is carried out. Possibility of maintenance of radiation of a crack in single-mode operation in the set range of frequencies with low factor of reflexion under condition of change of the geometrical sizes and crack position is shown. We specify recommendations about a purposeful choice of the sizes of a crack (width, length) and its positions in a wide wall of a wave guide. Reliability of settlement results is confirmed by their convergence on units of measure and check in boundary conditions.
Authors and Affiliations
N. M. Karashchuk, O. P. Cherkes, O. L. Sidorchuk
Keywords
Related Articles
- EP ID EP254847
- DOI -
- Views 138
- Downloads 0
Investigation of dynamic influence of rolling stock for the track structure
Are presented the results of experimental studies to evaluate the dynamic impact of rolling stock wheels with defects in the track structure. Was accomplished of evaluation the impact of movement speeds in the range of 1...
Determination of the complexity of bus routes under operating conditions
Technical operation, as a subsystem of road transport, significantly influence the efficiency of the transportation process and requires constant perfection, namely due to objective rationing (adjustment) of performance...
Determination of the optimum direction of mining works in the mining of blocks of natural stone
The possibility to use modern information and computer technologies to develop an integrated methodology for determining the optimum direction of mining works in the extraction of natural stone blocks is studied. The com...
Scientific and practical problems of reflection of land resources in accounting
The implementation of the land market in Ukraine actualizes the problems of accounting of land resources from viewpoints of generation of accurate and trustworthy information about quantitative, qualitative, and cost ind...
Processing accuracy control at the stage of CNC machines setting up for a program operation
The presented calculation of the parameters of shaping accuracy control makes it possible to form tool movement trajectories using the algorithms of adjustment, as early as at the stage of technological adjustment of the...