Research on Assembly Torque Attenuation of Steering Knuckle Cone Ball Stud
Journal Title: Automobile Technology & Material - Year 2024, Vol 39, Issue 2
Abstract
In order to eliminate abnormal sound of the knuckle cone ball stud of a passenger car on proving ground test, this paper proposed a new method based on virtual simulation. Firstly, the ball stud contact area variation tendency was simulated and the contact area critical preload was identified according to limit value of the road load data; then the residual preload under alternate working condition was simulated, and the residual preload was controlled larger than critical preload to avoid large contact area separation which will cause abnormal sound; finally,the tightening process was determined through joint test. The results show that this method can redefine the tightening torque, and the abnormal sound problem was eliminated successfully.
Authors and Affiliations
Cheng Wenzheng, Gou Ligang, Yu Xiaoqiao, Zhang Jun, Song Zihua
Keywords
Related Articles
- EP ID EP731943
- DOI 10.19710/J.cnki.1003-8817.20230058
- Views 26
- Downloads 0
Research on Electrode Tip Replacement Method Based on Linear Programming Model
Since the line has to be stopped when replacing the electrode tip, the Overall Equipment Effectiveness (OEE) improvement of the automatic production line and manufacturing cost of per vehicle will be affected directly. T...
Fracture Analysis and Rectification of Trunk Lid Torsion Bar Spring
In order to determine the fracture mechanism and cause of the trunk lid torsion bar spring, the fracture morphology, composition, size, material strength, microstructure and residual stress were tested, and a comprehen...
Analysis of Core Components of Proton Exchange Membrane Fuel Cell
At present, Proton Exchange Membrane Fuel Cell (PEMFC) has attracted people’s attention for the characteristics of high energy conversion efficiency, environmental protection and zero pollution. This paper analyzed the...
Nonlinear Optimization Design of Extruded Aluminum Sill Based on ESL Method
For the forward design of extruded aluminum door sill section in side pole crash condition, this paper analyzed the pros and cons of the Equivalent Static Load (ESL) based nonlinear optimization and traditional optimizat...
Solution of Section Parameter of Drawbead in Z-Direction Based on AutoForm
In order to solve the problem that the cross-sectional parameters of AutoForm drawbead could not be directly used in 3D software design, this paper derived solution formula for the cross- sectional parameters of Z-direct...