Research on Modeling of Land Leveling Problem
Journal Title: International Journal of Engineering Innovations and Research - Year 2018, Vol 7, Issue 4
Abstract
In this paper, how to choose the appropriate position and excavation depth in a piece of mountain was studied, so that the total amount of earth and stone was the smallest when the total cost of filling and excavation was saved as much as possible. The idea of grid method and limit differential was used, and more advanced data was obtained by interpolation from adjacent elevation points by using MATLAB software. According to the elevation of the design site in the actual elevation of the mountain area, the filling depth or the excavation height is calculated. According to the rectangular volume formula, the earthwork volume of the filling and excavating area in each grid could be obtained. The sum of the two was the total filling amount and the total excavation amount. When solving the problem of the position of the plane of the site, the position coordinates were represented by the points in the matrix, and then each point was traversed in turn by the enumeration method until the point with the smallest amount of earth and stone was found in consideration of the minimum total cost of filling and boring, thereby the area and altitude of the entire site were determined.
Authors and Affiliations
Xue Yao
Keywords
Related Articles
- EP ID EP498040
- DOI -
- Views 130
- Downloads 0
Effect of Earthquake Load on Column Forces in Concrete Frame Structures with Different Type of RC Shear Walls under Different type of Soil Condition
Shear Wall is A Structural Element Used to Resist Lateral, Horizontal, Shear Forces Parallel to the Plane of the Wall By: Cantilever Action For Slender Walls Where The Bending Deformation is Dominant. Truss Action for Sq...
Study of Mechanical Behaviour Natural Fibers Reinforced Composite Materials
In this work the investigation of experimental study of the evaluation of the different natural fiber as reinforcement with epoxy composites of mechanical properties. Composites were fabricated using Sisal/epoxy, Banana/...
Modal Analysis of a Non-rotating Inflated Tire using Experimental and Numerical Methods
A typical automotive wheel transmits noise and vibration from road to the automotive body structure, and considered as an important parameter in automotive NVH performance optimization. Having a reliable and simple finit...
Scale Development to Assess Instructors’ Intention to use Technology and E-Learning in Libyan Higher Education
This paper describes the development an instrument to assess faculty intention to use technology and e-learning in Libyan higher education (LHE). In spite of the research that has been conducted to examine the factors th...
Reducing Power, Leakage of Standard-Cell Design using Stack Transistor Logic Design
In this paper, a low leakage power optimizes CMOS layout designs. The approach is base on series-connected stack transistor technique. At first, the basic logic gate with conventional CMOS design and stack transistor bas...