Review of Feasibility and Use of Infinite Variable Transmission in Lathe Machine
Journal Title: GRD Journal for Engineering - Year 2015, Vol 1, Issue 1
Abstract
In today’s scenario objective of manufacturing industries to produce product of low cost, high quality in short time. Which give more quality product in less time and help in increase in industry’s profit this is done by selection of correct machine tool lets us focus on lathe, as we all know lathe machine is basic (generic) machine in manufacturing industry and maximum work is taken from it. Lathe machine works on three cutting parameter. That’s why the selection of correct cutting parameter is important. In lathe machine cutting parameters are depth of cut, feed rate and spindle speed (cutting speed). But as we know the spindle speed is limited and every material has their own optimum cutting speed. So that we focused on spindle speed generally power is transmit by gearbox and stepped cone pulley so that the output spindle speed is limited generally in kirloskar harihar D-1 lathe machine uses cone stepped pulley and number of output spindle speed is eight that is from four direct speeds and four from back gear.
Authors and Affiliations
Aakash Shah, Prof. B. S. Patel, Prof. J. P. Hadiya
A Technical Research – Multi Axes Ceiling Fan
A ceiling fan is a mechanical device usually electrically powered, Suspended from the ceiling of a room, that uses hub mounted rotating blades to circulate air. The electrically powered ceiling fan was invented by 1882 b...
Image Compression using DPCM
The Differential pulse code modulation (DPCM) [1, 2] may be used to remove the unused bit in the image for image compression. In this paper we compare the compressed image for 1 and 3 bit/pixel using DPCM and also compar...
Botnet Detection by Network Behavior Analysis
one of the most possible vulnerabilities to data available over network can be a botnet attack which can cause significant amount of data loss. A botnet attack is a type of malicious attack that utilizes a series of conn...
Evaluation of Effect of Bus Rapid Transit System on Urban Road using Vissim
Urbanization and change in life standards along with socio economic up gradation resulted in rapid growth of private vehicle ownership and use. This causes stress on the existing urban transport system. In urban area roa...
A Survey on Retinal Area Detector for Classifying Retinal Disorders from SLO Images
The retina is a dainty layer of tissue that lines the back of the eye within. It is situated close to the optic nerve. The reason for the retina is to get light that the focal point has centered, change over the light in...