Simulation of Explosive Welding with Reasonable Gap Based on ALE Method
Journal Title: International Journal of Modern Engineering Research (IJMER) - Year 2013, Vol 3, Issue 6
Abstract
In order to study the range of reasonable gap of explosive welding composite pipe, using Arbitrary Lagrange Euler (ALE) method to carry out Finite Element Analysis of explosive welding composite pipe, and simulating the dynamic process of explosive welding composite pipe in different gaps. The results showed that the influence of the gap to the collision speed, collision pressure, and effective plastic strain were obvious. While the collision speed increases with the increase of the gap, the collision pressure decreases with the gap increases, and the effective plastic strain was increased with the increase of the gap. The lower limit of the gap should meet that the composite tube collision velocity greater than the minimum impact speed. Combined with empirical formulas and experiment, a reasonable gap that was given by the simulation results is 0.5mm-0.8mm for such composite pipe.
Authors and Affiliations
Wei Deng
Keywords
Related Articles
- EP ID EP126119
- DOI -
- Views 124
- Downloads 0
Modeling and Transient Analysis of Wind Generator during Grid Voltage Drop
In recent years, wind energy has become one of the most important and promising sources of renewable energy, which demands maintaining better means of system stability. The performance of a grid-connected wind energy c...
A Qualitative Study of Public Expenditure Management: Case of Misappropriation in the National Budget of Nigeria
Public Expenditure Management (PEM) is a tool designed by the World Bank to ensure effectiveness and efficiency of public resources by various governments of the globe. PEM cannot be used in isolation of...
Influence of Skidded Distance on the Initial Velocity of Vehicle in Chain Accidents at Intersections
The objective of this study is to determine the influence of skidded distance on the initial velocity of the first vehicle in a chain accident at intersections involving three vehicles. Regression analysis on the r...
Vibration control of newly designed Tool and Tool-Holder for internal treading of Hydraulic Steering Gear Nut
In the internal turning operation, vibration is a frequent problem, which affects the result of the machining and in particular the surface finish. There will be several different actions to consider when solvi...
Implementation of Monitoring System for Cloud Computing
: As the benefits of cloud computing have increased, its utilization has been higher, but it has caused overload problems for virtual server. This paper implements the monitoring dashboard of cloud computing in ord...