Sno2-Wo3 Mixed Oxide as A Semiconductor Gas Sensor for Co2
Journal Title: International Journal for Research in Applied Science and Engineering Technology (IJRASET) - Year 2017, Vol 5, Issue 6
Abstract
SnO2 and WO3 oxide powders is mixed different composition thoroughly in an acetone medium by using a mortar and pestle and then heated at 9000C in a muffle furnace. The above mixed oxide powder is used to form a thick film by screen printing method. The sensors based on the mixed oxide were used to detect the CO2 gas at room temperature (303K).The experimental results show that the 45 mol.% SnO2-55 mol% WO3 mixed oxide based sensor exhibits the highest response( sensitivity = 12.45) on 802ppm CO2 gas at room temperature. The response and recovery time for all the sensors was studied. The average crystalline size was calculated from XRD spectra is ranging from 21.22mm to 23.10mm for mixed oxide powder whereas pure WO3 is 28.23mm.
Authors and Affiliations
S. M. Yenorkar
Keywords
Related Articles
- EP ID EP24697
- DOI -
- Views 371
- Downloads 13
Hand: Health Analysis using Nadi Detection – A Pervasive Approach
In modern world the chronic diseases like cancer and its types, diabetes, obesity, heart strokes etc are much dependent on surgical treatments where the analysis is done only after scanning the body, X-rays or through t...
Weather Forecasting System Using IOT
TheeInternet1of1Things (IOT)1is a couple1of1the primary innovative patterns which1is in support usual1to limitation genuine and vigorous obliged assertive to in the profound stop in foreseeing and distinguishing exigenc...
Utilization of Waste Material in Concrete Paver Blocks: A Review
Interlocking Concrete Block has been presented in India in development, 10 years prior, for particular requirement to be specific footpaths and parking areas and so on. Presently Interlocking Concrete Block Pavement is...
Modelling and Simulation of Three Phases to Seven Phases Transformer Connection
The main aim in this paper to build a three to seven phase AC multiphase transformers to converted into DC power through modelling and simulation. A new technique of pure seven-phase Sine-wave of fixed current/voltage a...
Multipath Routing With Directed Acyclic Graphs in MANETS
An approach for resilient multipath routing with independent directed acyclic graphs is presented in this paper and developed polynomial time algorithms to construct node independent and link independent DAGs using all...