Some Facts Resulting from the Key Variables Used in the Description of the Recuperative Heat Exchangers
Journal Title: Strojnicky casopis - Journal of Mechanical Engineering - Year 2018, Vol 68, Issue 3
Abstract
There are the various types of heat exchangers. The selection of the heat exchanger right type is the first basic assumption for its optimal operation. The heat exchanger calculation itself is another prerequisite for its optimal operation. This article deals with the variables which are usually used to describe the stationary operation of any recuperative heat exchanger with two incoming and two outgoing streams. The knowledge of these variables, including the facts resulting from them, is necessary not only from the point of view of the calculation but also from the point of view of the evaluation of the experimental data of any heat exchanger. The variables values needed for the calculation of heat exchangers, so-called key variables, must always fall within the values range determined on the basis of generally valid knowledge about heat exchangers. The article also deals with the determination of the limit values defining the values range of these key variables.
Authors and Affiliations
Štefan Gužela and František Dzianik
Keywords
Related Articles
- EP ID EP43960
- DOI https://doi.org/10.2478/scjme-2018-0038
- Views 202
- Downloads 0
Modeling of Coolant Flow Within the Spent Fuel Storage Pool of a VVER 440 Reactor
The article deals with modelling of coolant flow within the spent fuel storage pool of a VVER 440 reactor. The spent fuel storage pool is modelled in a state of standard reactor operation. The coolant heating from the...
Express Method to Estimate Structural Imperfection and Bone Tissue Status
A new method for evaluating the bone status using the scattering parameter of hardness indexes (Weibull homogeneity coefficient m) is proposed. A comparative analysis of the condition of the bone tissue of birds, depen...
Optimization of Sluice Gate under Fatigue Life Subjected for Forced Vibration by Fluid Flow
A ‘Sluice’ is a water-flow control gate works with sliding. So, it’s a mill race, flume or a penstock, channelling water towards a water mill, traditionally a wood or metal barrier sliding in grooves that are set in the...
A New Cable-Pulley Algorithm in RFEM
The cable-pulley system is widely used for its advantages. In this paper, application of a new algorithm for the calculation of cables on pulleys is presented. Unlike other algorithms, this algorithm enables to take th...
CFD Analysis of Downcomer of Nuclear Reactor VVER 440
The paper is focused on CFD analyses of the coolant flow in the nuclear reactor VVER 440. The goal of the analyses is to investigate the influence of the orifice diameter on the mass flow through individual fuel assemb...