Specificities of choosing of tolerances of the rolling bearings and of the parameters of geometry precision of the shaft and housing surfaces
Journal Title: Вісник Житомирського державного технологічного університету. Серія: Технічні науки - Year 2017, Vol 79, Issue 1
Abstract
The standards and methods concerning assignment of rolling bearing fit with shafts and frames via example of bearing 6-208 are analyzed. We set certain differences of recommendations according to GOST 3325-85, "Rolling bearings. Tolerance zones and technical requirements to mounting surfaces of shafts and frames. Attachment" and by reference of rolling bearing manufacturers. The following factors should be taken into consideration when assigning the mounting with the tension the internal ring of the bearing with shaft and mounting with a gap in the outer ring with a housing bore. The methods of achieving accuracy of mounting surfaces of shafts and frames via form tolerance assignment: roundness tolerance, profile of longitudinal cut, cross section, cylindricity and others. It is possible to limit the bearing rings in different ways, for example appointing the cylindrical mounting surfaces and bead end surfaces the appropriate tolerances, namely: coaxiality tolerance or full radial beat of mounting surfaces, and also perpendicularity tolerance, butt beats and full butt beats of mounting end surfaces. We suggest to expand methods of achieving the accuracy of shafts and frames depending on seriation of production and production operations metrology support.
Authors and Affiliations
Y. I. Adamenko, E. M. Herasymchuk, A. O. Kozachok
Keywords
Related Articles
- EP ID EP254674
- DOI -
- Views 94
- Downloads 0
The study of envorinmental state on road intersections based on emissions of car engines in Zhytomyr
This paper presents results of the studies of environmental conditions on road intersections based on car engine emissions in Zhitomir. Statistical methods were used to determine the intensity of traffic flows based on t...
Effect of the tangent of the cutting blade on the performance of machining
The kinematic schemes of turning with a blade tool with tangential displacement of the cutting blade are considered. Methods are shown for reducing the tension of the cutting process due to interruption and periodization...
The impact of hydrogen-bearing gas to change indexes of car engine in operating conditions
Due to lower oil and petroleum products there is a constant problem of the growing use of alternative fuels. One of the most promising is hydrogen, but its use as a self-fuel is rather difficult, but using as the form of...
Concession as the form of implementation of public-private partnership projects: the general description of accounting object
The article explores the reasons for the emergence of the need for public-private partnership. The study found out that the most important reason was the existence of a gap between the public tasks that were set and the...
Establishing patterns of destruction of naturally disturbed rock massifs by an explosion
It is noted that the effectiveness of explosive destruction of naturally broken and fractured rock massifs depends primarily on the strength and structural characteristics of rocks and the characteristics of the formatio...