Static Coefficient of Rolling Friction at High Contact Temperatures and Various Contact Pressure
Journal Title: Tribology in Industry - Year 2016, Vol 38, Issue 1
Abstract
The paper theoretically and experimentally analyzes the influence of increased temperature and load contact in the value of the coefficient of rolling friction. Theoretical analyzes show that at temperatures of the order of 200 0C, exist thermal potential necessary to narrow contact zone leads to a redistribution of the contact pressure and an increase in torque performance. Based on the measurement results, established the regression coefficient of friction depending on the temperature, normal load and geometry parameters of contact elements (radius of curvature of the contact elements). Material of examination contact pairs is steel ASTM A-295 hardness 64-66 HRC. The measurement results indicate a very significant impact on the temperature coefficient of friction, normal load and contact geometry (the radius of curvature of the contact elements). According to the authors future research should focus on optimizing the choice of materials that under the given conditions of mechanical and thermal load of contact to ensure a minimum value of the coefficient of rolling friction.
Authors and Affiliations
B. Tadić , V. Kočović , M. Matejić , Lj. Brzaković , M. Mijatović , Đ. Vukelić
Keywords
Related Articles
- EP ID EP143722
- DOI -
- Views 44
- Downloads 0
Influence of Composition of Plant Oils on Their Tribological Properties
Sunflower, corn, rapeseed, olive, and linseed oils were used for investiga-tion. Their fatty-acid compositions have been evaluated by gas chroma-tography. The tribological properties were determined with a four-ball mach...
Correlation between Surface Roughness Characteristics in CO2 Laser Cutting of Mild Steel
CO2 laser oxygen cutting of mild steel is widely used industrial application. Cut surface quality is a very important characteristic of laser cutting that ensures an advantage over other contour cutting processes. In th...
Experimental Study of Ageing Behaviour of Al-Cu-Mg/Bagasse Ash Particulate Composites
The experimental correlation of ageing behaviour for Al-Cu-Mg/Bagasse ash particulate composites with 2-10wt% bagasse ash particles produced by double stir-casting method has been investigated. Hardness values measuremen...
Characteristic Evaluation of Brake Block Material
This paper reports on a comparison of the frictional characteristics of three different samples of brake block materials. Two commercial brake blocks (composite and grey iron/metallic) and a non-commercial composite brak...
Performance Degradation Analysis of Aviation Hydraulic Piston Pump Based on Mixed Wear Theory
This paper focuses on the mathematical modeling of axial piston pump through dividing the failure development of friction pair into lubrication, mixed lubrication and abrasion. Directing to the wedge-shaped oil film betw...