Stress strain analysis for the face milling cutter to achieve a proper surface finish
Journal Title: Вісник Житомирського державного технологічного університету. Серія: Технічні науки - Year 2019, Vol 83, Issue 1
Abstract
According to an analysis of published works by the authors who investigated the process finishing machining operations the parts by the face milling cutter, the feasibility of using face milling processes for the final formation the surface layer of the parts to be machined is established. In doing so, using face milling of oblique cutting with equipped with super hard materials and a spiral-step arrangement of the cutting elements have significant advantages. However, the non-stationarity cutting process, which characteristic for the face milling processes, leads to variable deformations of the technological system, which negatively characterize the quality processing affects. The study of the authors of the stress-strain state (for one of the technological system components) allowed determining of the cutter body deformation process, which leads to a change position of the cutting edges, and that in turn to affect the machined surface. The measured values of axial displacement the cutters allow predicting the machined surfaces quality and to develop measures for tool deformations eliminated in the non-stationarity face milling condition process.
Authors and Affiliations
H. M. Vyhovskyi, M. M. Plysak
Keywords
Related Articles
- EP ID EP621767
- DOI -
- Views 108
- Downloads 0
The optimization technique of highway trucks fleet joint schedule with time limits
The article deals with the problem of operative management of highway road trains fleet, which performs freight traffic. To increase the efficiency of their use, precise interaction of customers and road trains is requir...
The short-wave broadband communication device for transmission the analog narrowband signals
The transmission of information via the radio channel always involves the selection of radio waves modulation and the frequency band occupied by the radio signal. For the narrowband analog signals, the transmission via t...
Research of the direction of dynamic-sustained sensitive element
The article is devoted to the investigation of the behavior of a dynamically tunable sensitive element (DTSE) of an armor stabilizer with the help of the DCM, when it influences disturbing factors of different nature (fr...
Investigation of low-frequency chatter during machining with ball end mills
In this study the investigations of low-frequency oscillations of technological system during machining with ball-end mill of inclined surface were made. An influence of non-linear components of cutting process on change...
The impact of hydrogen-bearing gas to change indexes of car engine in operating conditions
Due to lower oil and petroleum products there is a constant problem of the growing use of alternative fuels. One of the most promising is hydrogen, but its use as a self-fuel is rather difficult, but using as the form of...