STUDY FOR THE VARIATION OF HARDNESS AND RESILIENCE CHARACTERISTICS AFTER HEAT TREATMENT FOR STAINLESS STEELS
Journal Title: TEHNOMUS - Year 2011, Vol 18, Issue 1
Abstract
The paper presents tests of the stainless steel. This material was subjected to heat treatments, afterwards conducted impact bend tests and hardness measurements. Using the data was drawn graphic variation of hardness and resilience depending on the condition of structural material (hardened, annealed, solution treated and aged).
Authors and Affiliations
Manuela Cristina Perju, Dragoş Cristian Achiţei, Carmen Nejneru, Anca Elena Lărgeanu, Mihai Axinte, Ion Hopulele
Keywords
Related Articles
- EP ID EP155423
- DOI -
- Views 75
- Downloads 0
RESEARCHES CONCERNING THE CORRELATION STRUCTURE OF PROPERTIES OF STEELS FOR METAL CONSTRUCTIONS STRONGLY REQUESTED
The RV52 steel plates are used to manufacture liquefied and compressed gas reservoirs, recipients and pressure vessels which operate at low temperatures, big pressures and highly loaded structures . The making technology...
USING VIRTUAL PARTS TO OPTIMIZE THE METROLOGY PROCESS
In the measurement process, there are many parameters affecting the measurement results: the influence of the probe system [3,5,7,15,10,16,17,19,21], material stiffness of measured workpiece [7], the calibration of the p...
ABOUT NATIONAL STRATEGY OF ROAD SAFETY IN PRESENT AND FUTURE
After the year 1990, the car park and also the number of drivers have almost tripled, being in a complete contradiction with the slow development of the infrastructure, leading to an increase in the percent of material a...
SURFACE ROUGHNESS VARIATION IN BALL END MILLING OF C45 MATERIAL. PART I: INCLINATION OF TOOL AXIS IN FEED POSITIVE DIRECTION
This paper primarily presents important experimental results, about surface roughness variation in ball end milling, for the case of tool axis inclination in feed positive direction. Secondary, using experimental results...
THEORETICAL CONSIDERATIONS ABOUT ENERGETICAL PARAMETERS OF SHEET METAL BENDING ON MACHINES WITH ROLLERS
The paper presents a theoretical stress and deformation state analysis in plastically bending with cold-hardening sheet metal. With the relations established it have determined the inner deformation forces, moment with t...