Study on Single Step Method for Synthesis of Nano Fluids

Abstract

This project primarily focuses and uses one-step chemical reduction method for synthesizing copper nanofluids by reducing copper sulfate by sodium hypophosphite using microwave irradiation. Thermal conductivity of the product obtained is measured and the variation of thermal conductivity with pH and concentration of precursor is studied. Stability of the dispersion formed is studied by measuring zeta potential at different pH values. One-step method for synthesizing nanofluids has been used to produce nickel nanofluids and properties of the product formed were studied by transmission electron microscopy and x-ray diffraction techniques. High energy ball milling was used to produce copper nanoparticles to be used in the two step method for synthesizing copper nanofluids. The effect of milling time on the size of the crystallites formed was studied.

Authors and Affiliations

Kiran Kumar

Keywords

Related Articles

Effects of Nitrogen and Phosphorus on the Growth Performance of Maize (Zea mays) in Selected Soils of Shahdol (M.P.) Vindhyan Regions

The study was carried out in Shahdol (M.P.). Soil samples were collected from six locations within Shahdol (M.P.) namely Burhar, Jaitpur, Shahdol, Gohparu, Jaisinghnagar and Beohari. Surface soils (0-15 cm) and sub-surf...

Bidirectional DC-DC Converter with MPPT Controller Using PV Array

This paper proposes simulation of Bidirectional DC - DC converter with Maximum Power Point Tracking using Photo Voltaic cell with motor load in boost and buck mode respectively. The proposed two level converters have th...

A Power Equalizer for Shaded PV Module

This paper deals with a photovoltaic (PV)-module embedded power-electronics topology derived from a battery equalizer. The photovoltaic equalizer is a promising response to the problems of partial shading in photovoltai...

Power Quality Improvement using Super Capacitor for an Isolated Power Generation

Power generation will be formed in many weak distribution networks, after renewable energy sources are connected to them. It is very important to increase the reliability and efficiency of using these renewable energy s...

Fast Base-10 Multiplication Using XS-3 and ODDS BCD codes

We present the algorithm and architecture of a BCD parallel multiplier that exploits some properties of two different redundant BCD codes to speed up its computation: the redundant BCD excess-3 code (XS-3), and the over...

Download PDF file
  • EP ID EP23174
  • DOI http://doi.org/10.22214/ijraset.2017.2086
  • Views 237
  • Downloads 6

How To Cite

Kiran Kumar (2017). Study on Single Step Method for Synthesis of Nano Fluids. International Journal for Research in Applied Science and Engineering Technology (IJRASET), 5(2), -. https://europub.co.uk/articles/-A-23174