STUDY ON THE BREAKDOWN OF MILLING BALLS MADE OF 13%Cr WHITE CAST-IRON WORKING IN STRONG ABRASIVE AND CLASH CONDITIONS
Journal Title: Journal of Mechanical Engineering Research & Developments (JMERD) - Year 2019, Vol 42, Issue 2
Abstract
The breakdown due to abrasion and clash of the milling balls made of 13% Cr white cast iron is a complicated process which depends on many factors, especially on the strength of the matrix and carbide phases. As shown, stresses created by abrasion and clash processes are concentrated mainly at the locations such as carbide/matrix boundary and around coarse carbide particles, leading to the cracks and breakdown there. The peeling off carbide particles can be a reason of scratches on the specimen surface. Heat treatment (quenching in oil and tempering at 2500 C for three hours) to transform a soft matrix (austenite) to a harder one (martensite) can be a good solution against abrasion. Concerning the impact, the solution should be the refinement of the carbide particles and their uniform distribution.
Authors and Affiliations
Hoang Thi Ngoc Quyen, Nguyen Hong Hai, Vu Viet Quyen, Nguyen Van Bach, Vu Anh Tuan, Nguyen Duong Nam
Keywords
Related Articles
- EP ID EP503674
- DOI 10.26480/jmerd.02.2019.98.100
- Views 96
- Downloads 0
CORRELATION OF OVERALL HEAT TRANSFER COEFFICIENT IN THE THREE ZONES OF WIRE AND TUBE CONDENSER
Numerical and experimental analysis has been studied to estimate the overall heat transfer coefficient in the three zones along wire and tube condenser. The model is based on the empirical formulation of the refrigerant...
DATA MINING IN MECHANICS
The article is devoted to analysis of data mining techniques in a model of construction management. It is advisable to apply some well-developed methods of fuzzy sets and fuzzy logic. The original construction is describ...
A STUDY ON THE FACTORS AFFECTING THE FLARE OF THE WELD WHEN WELDING THE STEEL WIRE
In this study, an equation for adjusting the parameters affecting the flare of the weld on the welding product was established. Based on the empirical research results, the factors affecting welding flux after using bend...
HIGH PERFORMANCE WATER TREATMENT TECHNOLOGY FOR THE RESERVOIR PRESSURE MAINTENANCE AT OIL FIELDS
This article considers the problem of deterioration of permeability of reservoirs in the bottom-hole zone, as well as the problem of decrease of water intake capacity of water injection wells due to colmatation of pores...
THE PROSPECTIVE PROCESSING LINE FOR THE PREPARATION OF COMPLETE FE ED FOR LONG-TERM STORAGE
An important condition for increasing the livestock production efficiency and production of livestock products and reducing their cost is full-value feeding, the provision to the farm animals complete multicomponent feed...