Study on the Influence of Carbon on Standardized and Non-standardized Steel
Journal Title: Acta Marisiensis. Seria Technologica - Year 2019, Vol 16, Issue 1
Abstract
The way a piece or tool behaves in operation is determined by the quality of the material from which it is made, the precision of execution and heat treatment applied. In the present research, it is highlighted the differences that take shape after heat treating different materials (low carbon steel and high alloyed steel) including heating to dissimilar austenitic phases (880°C and 1020°C), holding for non-identical times, tempering at low temperature (260 °C) and then cooling by using separate cooling mediums (oil, air and water). The results show no noticeable increase in the hardness and mechanical properties for the low carbon steel after the heat treatment, but on the other hand, the high alloyed steel, reveals distinguishable changes in both hardness and mechanical properties. There is a close link between the structure, the parameters of the thermal processes and the properties that are desired so that future specialists have to assimilate the basic knowledge related to the phenomena that occur during a heat treatment but at the same time it is important to equip the companies with machines and measure devices, like a spectrometer.
Authors and Affiliations
Liviu Pop
Optimal Charging of Electrical Vehicles in the Smart City for Loss Minimization and Voltage Improvement
The world is two-thirds of the way through a century-long cycle of rapid urbanisation, at the end of which more than 70% of people will live in cities (World Health Organization, 2014). The urban transformation has becom...
Nonlinear Circuit Elements Influence on the Power Network
This paper presents the most important nonlinear circuit elements, the equivalent circuits and the causes of nonlinearity. This is important because the power quality in the power network is strongly influenced by the no...
Study Regarding the Optimization of Corn Production According to Hectolitric Mass and Seeding Time
This article approaches the nonlinear regression model, the method of the smalles squares with examples, and calculations for the power function model. For this, we used data obtained from a study using corn hybrids such...
Existence of Positive Solutions for an Elastic Curved Beam Equation
This paper investigates the existence of positive solutions for a sixth-order differential equations. By using the Leggett-Williams fixed point theorem we give some new existence results.
Mathematic Modeling of Experimental Results on the Influence of Technological Factors on Production in Some Energy Crops
The present article, based on data obtained from a study which analyzed the influence of technological and ecological factors on rape plants (Brassica napus) production capacity - the Bolero variety – approaches the mode...