Study on transient characteristics of centrifugal pump<br /> during starting period<br />
Journal Title: Science Paper Online - Year 2009, Vol 4, Issue 9
Abstract
In order to research the transient explicit performance and transient flow of the centrifugal pump during starting period, this paper introduces the transient performance test, the numerical simulation of transient flow and explicit performance. The experimental method of the transient performance and numerical simulation method of inner flow are present. The results show that the head and flow rate increase with the rotational speed. When the start time is shorter, the impact head is obvious. The method of generalized equation is used to predict the explicit characteristics of the centrifugal pump during starting period. The numerical simulation model of three-dimensional transient flow is established by dynamic mesh method and sliding mesh method, and LES simulation is used to describe the turbulent flow. The numerical results compared with the experimental results achieve better consistency, which verify the feasibility of three-dimensional transient flow numerations of the centrifugal pump during starting period.
Authors and Affiliations
Binjie Xu, Zhifeng Li
Keywords
Related Articles
- EP ID EP96888
- DOI -
- Views 119
- Downloads 0
Critical diffusible hydrogen concentration for blistering of a micro-alloyed clean wheel steel
The critical diffusible hydrogen concentration for hydrogen blistering of a micro-alloyed clean wheel steel was measured using the electrolytic hydrogen charging method. The results show that the diffusible hydrogen conc...
纳米In2O3-TiO2光催化膜的表征及降解甲苯研究
本文采用溶胶－凝胶法制备了纳米In2O3-TiO2复合溶胶，经多次镀膜得到以铝片为载体的纳米In2O3-TiO2复合膜，以空气中的甲苯为模拟污染物，考察了其光催化性能。结果表明，In2O3的复合对TiO2光催化活性起到促进作用，n(In2O3)/n(TiO2)=0.04...
真菌漆酶对蒽醌和偶氮类活性染料的脱色
采用酶学技术脱色/脱毒纺织染料是环境生物技术领域研究的热点。以真菌5319漆酶粗酶液对2种蒽醌类和3种偶氮类纺织活性染料进行脱色，实验研究了温度、pH、染料浓度、给酶量和介体对脱色效率的影响。在pH 4.5、给酶量10 U/L、45 ℃条件下，...
Feature-preserviFeature-preserving mesh denoisingng mesh denoising
A mass of 3D meshes are obtained by 3D scanning, and it’s a key problem to eliminate the noises causing by scanning process. Bilateral filtering is used very successful in image denoising, it can also be used in mesh den...
纳米晶CuAl2O4的合成、表征及光催化性能研究
本文通过有机物前驱体法制备尖晶石型CuAl2O4纳米晶，利用TG-DTA、XRD、TEM、UV-VIS等分析手段表征了前驱体和CuAl2O4粉体。结果表明，CuAl2O4在热处理中出现了CuO中间相，经900℃焙烧得到单相CuAl2O4。800℃的CuAl2O4的禁带宽度为1.92 eV，...