Study to Determine the Gaseous Emissions from the Combustion Gases
Journal Title: RECENT - Year 2014, Vol 15, Issue 43
Abstract
The paper presents some aspects about measurement of the pollutants emissions from a heat treatment plant. Responsibility belongs emissions monitoring equipment operators, environmental authorities and organizations involved (authorized organizations- companies, laboratories, operators are empowered to make measurements of emissions of air pollutants from large combustion plants). In this paper, the practical examinations were made in collaboration between author and the Monitoring Department from the Environmental Protection Agency of Brasov, conducted in a company’s "Metrom Industrial Park", the source of pollution was a tempering furnace fuelled by natural gas for heat treatment. Sampling points were: before and after the filter basket mounted on the exhaust gas inside the oven. It was used a gas analyzers TESTO 350 XL - a performance equipment to determine gaseous emissions from the combustion gases. All the determinations were done in special cells, following chemical reaction type Peltier. Analyzed gases are: SO2, CO, CmHn, O2, NO and NO2. Following the experimental determinations, it can be concluded that they exceeding the emission limit values for the indicator of carbon monoxide (CO), both before and after the filter, gives a hot-performing incomplete combustion.
Authors and Affiliations
Ioan MILOȘAN
Keywords
Related Articles
- EP ID EP94740
- DOI -
- Views 109
- Downloads 0
Artificial Neural Network Based Short-Term Hydrothermal Scheduling
A worldwide trend in the development of power systems is to build interconnections with the goal to achieve economic benefits. Interconnections of power systems may offer significant technical, economic and environmental...
Theoretical Analysis Regarding the Asymmetrical Fluid Flow Applied to Helicopter Aerodynamics
The main topic of the present paper is the asymmetrical fluid flow application with the purpose of finding the best solutions to replace the anti-torque rotor of single-rotor helicopters using the Coandă Effect. This wou...
Simulation Driven Improvement of Worm Gearset Performance Using Virtual Prototype
This study aims to present a contemporary approach for improvement of gearset output performance, based on virtual prototype. Powerful advantage of accessing gears parameters in detail at early stage of product developme...
Medical Recovery System of the Upper Limb Muscles
Starting from the study of arm and forearm biomechanics the paper presents a device for mobilization and rehabilitation of the upper limb muscles, conceived for patients with a reduced mobility of this limb requiring rep...
Upon the Ordination of the Gear Ratios in the Bicycle Chain Gearing
Chain gears used for bicycles may be simple, which achieve a single gear ratio, or complex, in which the gear ratio takes several discreet values. Through regulating the gear ratio, the bicycle advancement speed is in fa...