Synthesis of the structure for the optimal system of flow treatment of raw materials
Journal Title: Восточно-Европейский журнал передовых технологий - Year 2018, Vol 5, Issue 2
Abstract
<p>This paper demonstrates that contemporary studies into optimization of technological processes do not take into consideration in the models of systems and in the applied criteria the requirements to the overall efficiency of the process and compliance with the objectives of the owner of a privately-held industrial enterprise. This necessitates the reduction of cost and time of a technological operation, as well as maximization of the added value of the primary product.</p><p>The effectiveness of the system of a flow treatment of raw materials is estimated using a specialized model, which was synthesized in the course of this work. The proposed model is different in that it includes units to calculate the unit cost of a product depending on the quality indicator and the degree of correspondence to the proposed quantitative and qualitative constraints. There are calculation units for the dynamics of change in a qualitative indicator of the finished product depending on a flow of raw materials and the energy supplied to treatment. The units are also required to calculate the consumption of resource and energy for the transporting and treatingg parts of the system in the interval, defined as the time taken for a conditional batch to pass through the installation.</p><p>Using the developed model makes it possible to determine the value for the performance indicator for any permissible technological mode and to perform a global optimization of the process. Thus, there is a transition from the requirements to efficiency in general terms to setting the technological process parameters.</p><p>Here we propose the analytical form for a performance indicator, suitable as an optimization criterion for modes of the technological installation with a continuous supply of raw-material and energy products.</p><p>We have experimentally studied a model of the flow-through electric heater with units that calculate time and cost parameters, which has demonstrated its adequacy. The developed optimality criterion was verified and the possibility of its application was proven for determining the optimal permissible operating modes of the technological equipment with a continuous supply of raw materials and energy.</p>
Authors and Affiliations
Igor Konokh
Research into energy characteristics of single-phase active four-quadrant rectifiers with the improved hysteresis modulation
<p>The traction electric drives for electric rolling stock of alternating current employ the diode and thyristor rectifiers that predetermine a series of shortcomings. These include the significant emission of reactive p...
Synthesis of energyefficient acceleration control law of automobile
<p>We have established the laws of change in the vehicle acceleration time at the existing step transmission of ICE, when implementing the total traction force, boundary for the drive wheels adhesion to the road, and dur...
Numerical study of the process of compressing a turbulized two-temperature air charge in the diesel engine
<p>We have investigated the issue on improving energy efficiency of systems that facilitate the start of diesel engines by heating the air charge. The enhanced energy efficiency is based on the heating of part of the cha...
Development of test operations with different duration in order to improve verification quality of effectiveness formula
<p>Selection of an indicator for assessment of effectiveness of operations is a very essential step, because this choice predetermines the mode of operation for all functional systems at an enterprise.</p><p>An axiom is...
Interlaboratory comparisons of the calibration results of signal generator
<p>The data of interlaboratory comparisons of calibration results of signal generators at three calibration points are presented. The choice of methodology for processing the results of interlaboratory comparisons is mad...