The choice of diamond powder for vibro-abrasive processing of cutting inserts from composites based on cubic boron nitride
Journal Title: Вісник Житомирського державного технологічного університету. Серія: Технічні науки - Year 2017, Vol 80, Issue 2
Abstract
The article presents the results of experimental studies of the possibility of vibro-abrasive processing of samples with PNTM on the basis of CNB using suspensions, yaks have in their warehouses diamond powders in various concentrations. It has been established that the greatest removal in vibro-abrasive processing of samples with PNTM on the basis of CBN provides the use of a suspension containing a diamond powder ACM. The largest amount of removal (0,009 mg / min) occurs when processing samples of the plate type using a suspension of diamond powder ACM at a concentration of 15 %. For the simultaneous processing of samples such as plates and cylinders, it is advisable to use suspensions with diamond powders ACM and AC6 at a concentration of 10 %.
Authors and Affiliations
V. I. Burlakov
Keywords
Related Articles
- EP ID EP256818
- DOI -
- Views 74
- Downloads 0
Formation of effective organizational structure of accounting service
The purpose of the article is to determine the optimal organizational structure of the accounting service to improve the performance of this unit and the enterprise as a whole. The influence of factors of the accounting...
Influence of Nonlinear Environmental Properties on the Process of Pulse-Stimulated Compulsory Combined Scattering under Femtosecond Pumping Conditions
Impulsive stimulated Raman scattering (ISRS) observed by pump-probe experiments was considered. The response from the model system for ISRS-process is calculated for femtosecond laser pump pulse. The response of the mode...
Optimization system of excavation work on a quarry on the criterion of minimum energy consumption
One of the most effective ways to save energy in a quarry is optimization of operational regimes of excavators on the criterion of energy intensity. For excavators, the parameters of regimes of work, related to the optim...
Influence of kinematics of magnetic abrasive machining on the quality parameters of the working surfaces of high-speed steel
The influence of the kinematics of the process of magnetic abrasive treatment on the quality of work surfaces of taps with a profile angle of 60° is investigated. The influence of the conditions of the base of the taps i...
Synthesis of a quasi-optimal regulator of conveyor load of a mining company using the concept of the Pearson method
The use of conveyor loading control systems allows to ensure maximum energy efficiency of equipment operation. At the same time, the presence in the control loop of a link of pure delay and non-linear expression on state...