The Dependence of Castings Quality Produced in Clay Moulding Mixtures from the Properties of Binder Based on a Montmorillonite
Journal Title: Archiwum Odlewnictwa - Year 2012, Vol 12, Issue 3
Abstract
Casting quality depends on many factors including the quality of the input materials, technology, material securing and last but not least, the mould into which the casting is casted. By pouring into a single-shot mould, based mainly on 1st generation binders, is is a very important factor. Basically, a bentonite mixture represents either a three- or four-component system, but each component of the system is a heterogeneous substance. This heterogeneity punctuates mainly a non-stationary heat field, presented throughout the whole process of the casting production. The most important component is a binder and in the case of first generation binders mostly bentonites are used - clays that contain minimum of 80% of montmorillonite.
Authors and Affiliations
I. Vasková, D. Fecko, J. Malik
The technology of precision casting of titanium alloys by centrifugal process
The article describes the development of a procedure for the preparation of foundry ceramic moulds and making first test castings. The presented studies included: development of technological parameters of the ceramic...
Quality of carburizers and its influence on carburization process
In the papers issue of production the synthetic cast iron obtaining on the basis of only steel scrap and carburizing materials are presented. Natural graphite, synthetic graphite, anthracite, petroleum coke, foundry coke...
Influence of pressure mould material on the durability of coating a thermal and anti-erosion barrier
This study presents the research results of the durability of coating (thermal and anti-erosion barrier) of a mincer cap casting pressure mould. Tests were conducted with the use of an IDRA OL320 pressure machine. Durabi...
Advanced oxidation and adsorption modification of dust waste from standard moulding sands
The article discusses the process of advanced oxidation (AO) with application of ultrasounds and surface modification of the dust waste collected during dry dedusting of processed moulding sands with bentonite binder. A...
Residual stress state in titanium alloy remelted using GTAW method
Test materials comprised two-phase titanium alloy Ti6Al4V (Grade5). The surface of the tested alloy was remelted by means of TIG welding method using variable current-voltage parameters. The investigations aimed to deter...