THE EFFECT OF THE AMORPHOUS CONTENT OF LASER CLADDING Ni-Nb-Zr/CaF2 ON MICROSTRUCTURE AND PROPERTIES
Journal Title: Journal of Machine Construction and Maintenance - Year 2018, Vol 111, Issue 4
Abstract
Ni-Nb-Zr/CaF2 amorphous coating was prepared on the surface of SA283GRA steel by adopting a high-power laser cladding system. The results show that the Ni-Nb-Zr/CaF2 coating obtained by laser cladding has a good metallurgical bonding with the matrix of SA283GRA and the amorphous phase was obtained. The different amorphous content was obtained with varied laser power. With the increase of laser power, the dilution rate of the coating gradually increases, the amorphous phase content in the cladding coating decreased gradually, and crystallization near the substrate is significant in the laser coating. As the cladding coating is far from the substrate, the content of amorphous phase increases gradually, and the cladding coating has high thermal stability. The hardness of the Ni-Nb-Zr/CaF2 amorphous coating prepared by a laser power of 4 kW is up to the highest value of 890 HV, which is about 4.7 times that of the base material. The electrochemical corrosion results show that the corrosion resistance of the amorphous layer is better than that of the substrate in NaCl solution with 3.5% corrosive medium. The Ni-Nb-Zr/CaF2 laser coating has a relatively strong amorphous forming ability.
Authors and Affiliations
Xiubing Liang, Yanhai Cheng, Xiaoqian Cheng, Yichao Jiang, Tadeusz KuLiK, Jarosław Ferenc
Keywords
Related Articles
- EP ID EP614180
- DOI -
- Views 183
- Downloads 0
ASSESSMENT OF ALTERNATIVE SURFACE MODIFICATION TECHNOLOGIES FOR IMPROVED ADHESION OF COATINGS AND ADHESIVES TO AUTOMOTIVE POLYOLEFINS
Thermoplastic olefins (TPO’s) are important materials for the manufacture of exterior and interior automotive components due to their low cost, reduced specific density in comparison with other types of plas...
SUBSYSTEM OF POSITIONING THE ACTUATOR FOR AN ELECTRONIC DIESEL CONTROL SYSTEM
The authors proposed the concept of the synthesis of the algorithm for the electronic diesel controller (EDC), based on the analogy with the operation of a mechanical spring-lever governor of direct action. The system of...
TUNGSTEN DOPED TiB2 COATINGS OBTAINED BY MAGNETRON SPUTTERING
The aim of the work was to investigate the possibilities of shaping the properties of TiB2 coatings by doping with tungsten, which create hard boron phases (e.g., WB2, WB4, and W2B5). The coatings were produced by a DC m...
MODELLING OF COMPOSITE ELEMENTS OF POWER TRANSMISSION SYSTEMS CONSIDERING NONLINEAR MATERIAL CHARACTERISTICS
Engineering calculations of elements of the power transmission systems made of high-strength carbon-epoxy and carbon-aramid composites are very difficult due to the lack of reliable data concerning non-linear features of...
MONITORING THE OPERATIONAL PARAMETERS OF A POWER ROOF SUPPORT
Safety aspects of mining personnel as well as the safety of the coal mining processes are presented. A mechanised longwall system is commonly used in the coal mining industry. The system consists of the basic machinery,...