The Experimental Study of Heat Transfer Coefficient of Al2o3/Water Nano Fluid by Using Double Pipe Heat Exchanger

Abstract

The heat transfer coefficient of Al2O3/Water nanofluid is investigated experimentally in this paper. This Experiment is done with the help of double pipe heat exchanger. The Al2O3 nanofluid is prepared by dispersing an Al2O3 nanoparticle in deionized water. Al2O3 /Water nanofluid with a nominal diameter 20nm at different volume concentration (0.4&0.8 vol %) at room temperature was used for this investigations. The result of this experiment proves that the convective heat transfer coefficient increases with an increase in time and also the Nusslet number increases with increasing the liquid flow rate.

Authors and Affiliations

Tharoon T

Keywords

Related Articles

Improvement in Polysulfone(PSf) Film Properties by Porogen Concept

Polysulfone (PSf) is the most widely used polymer for preparation of ultrafiltration membranes. Its preparation need to be optimized to obtain membranes with desired qualities. PEG can be used as porogenic additive in t...

In Vitro Studies of Ficus carica and its Application in Crop Improvement

Recent advances in cell culture and molecular biology of higher plants, which are key components of plant biotechnology, have demonstrated the considerable power and potential of these technologies in the genetic modifi...

Primary user signal detection over fading channel in the presence of weakly correlated noise

The rapid deployment of new wireless devices and application leads to increase in demands for wireless radio spectrum. But the fixed spectrum assignment policy becomes a bottleneck for more efficient spectrum utilizatio...

Design High Speed Doubles Precision Floating Point Unit Using Verilog

To represent very large or small values, large range is required as the integer representation is no longer appropriate. These values can be represented using the IEEE-754 standard based floating point representation. T...

A Design to Improve Performance of Sheet Metal Dies

This paper presents design of sheet metal die mould for protection cap. The review provides information about various design parameters concerned with Sheet Metal Die design. In order to make a product of sheet metal re...

Download PDF file
  • EP ID EP24480
  • DOI -
  • Views 292
  • Downloads 9

How To Cite

Tharoon T (2017). The Experimental Study of Heat Transfer Coefficient of Al2o3/Water Nano Fluid by Using Double Pipe Heat Exchanger. International Journal for Research in Applied Science and Engineering Technology (IJRASET), 5(6), -. https://europub.co.uk/articles/-A-24480