The Experimental Study on the Machining Conditions of Heat Treated Medium Carbon Steel using Ceramic Cutting Tool
Journal Title: International Journal of Mechanical and Production Engineering Research and Development (IJMPERD ) - Year 2019, Vol 9, Issue 4
Abstract
The current study shows the effect of various heat treatments on the cutting force and surface finishing of machining for medium carbon steel (0.522C) with different cutting conditions have been investigated. In this research, samples have been divided into two groups. Samples of the first group were heated to austenitizing temperature and quenched in a polymer solution (Polyethylene glycol M. W.400), followed by tempering. Tempering process is to reduce brittleness and relieve residual stresses. In this treatment, the samples were heated again to 450○C, held for one hour at that temperature (soaking stage), then cooled in still air. Samples of the second group were heated to austenitizing temperature and cooled by air (normalizing process). The cutting force and other properties were evaluated before and after heat treatment. The results showed a direct effect of heat treatments on cutting force and machinability. In other words, a correlation between the machinability and the heat treatment of specimens was established.
Authors and Affiliations
Sattar Hantosh A . Alfatlawi, Nofel Z. Whieb, Wafa Mahdi Jodia
Keywords
Related Articles
- EP ID EP656901
- DOI 10.24247/ijmperdaug2019118
- Views 87
- Downloads 0
CFD ANALYSIS OF HUMAN POWERED SUBMARINE TO MINIMIZE DRAG
This paper deals with finding the optimum fineness ratio, i.e. ratio of length to maximum diameter, of human -powered submarine of different shapes to reduce the drag force on the body using Computational Fluid Dynamics...
Development and Optimization of Experimental Data based Models for Bamboo Sliver Cutting by using Human Powered Flywheel Motor
This paper presents the development of the experimental data based mathematical models for cutting the slivers from bamboo by means of human powered flywheel motor. There were various dependent and independent variables...
Evaluation of Roughened Duct with Similar Wideness Gap of Arc with Staggered Link and Comparison with Similar Rib Roughness Geometries
This paper introduces new roughness used in roughened duct and evaluates the effective performance for wideness gap of arc with staggered link geometry. The present new roughness geometry has parameters like obstacle pit...
Artificial Intelligence Based Green Manufacturability Quantification of a Unit Production Process
Environmental awareness and sustainability among consumer is increasing since past decade. These consumer activity forces the industry to maintain the environment, and it began to trouble them to balance the monetary and...
DEVELOPMENT OF METHODOLOGY OF THE HEAT SINK THERMAL ASPECT FOR LOW COST EFFECTIVE CFD SOLUTIONS FOR REASONABLY HIGH QUALITY DESIGN
The present focus is to optimize thermal aspects for low cost effective CFD solutions of the analysis of the reasonably high-quality design. Although the method adopted for the current study is a well-known idea that is...