THE INCREASE OF PLOUGHSHARE TEMPERATURE AS THE EFFECT OF SOIL FRICTION DURING WORK
Journal Title: Tribologia - Year 2014, Vol 253, Issue 1
Abstract
The surface temperature of ploughshares was measured during ploughing carried out in two conditions. Measurements were taken at two points on the surface of ploughshare using a contact thermometer and by means of thermal imaging of the whole surface. It was found that, depending on the working conditions, the surface temperature measured at two points of ploughshare was higher by about 4 to almost 9°C than the temperature of the cultivated soil. The surface of the bow section of the ploughshare underwent stronger heating, probably due to more soil stress. It was also found that pre-treatment of the surface of ploughshare to take measurements with thermal imaging cannot be used to determine the temperature distribution on the surface. A number of factors may affect the value of the ploughshares’ operating temperature, the importance of which requires experimental confirmation.
Authors and Affiliations
Piotr KOSTENCKI, Tomasz STAWICKI
Keywords
Related Articles
- EP ID EP263764
- DOI -
- Views 60
- Downloads 0
THE CHARACTERISTICS OF THE WEAR OF THE STAMP USED IN BACKWARD EXTRUSION OF STEEL ELEMENTS
This research is aimed at the analysis of wear mechanisms of 32CrMoV12-28 steel stamp used in extrusion of railway bumpers. The stamp cracked, which excluded it from further use. The analysis of the stamp material was pe...
DISCUSSION ABOUT FUNDAMENTAL PROBLEMS OF TRIBOLOGY. PART 12 – SYSTEMATIC OF RESEARCH ACTIVITY IN TRIBOLOGY – FROM STRATEGY TO TACTIC TRIBOLOGY RESEARCH
This paper presents an attempt at systematising the issues of tribology research according to the criterion of general cognitive tasks. The existing structure covering strategy, operational art and tactics were used for...
THE INFLUENCE OF THE CONDITIONS OF INVESTIGATIONS ON TRIBOCORROSION OF STEEL AISI 304 IN SOLUTION OF 0.5 M H2SO4
The paper presents the results of tests of tribocorrosion wear of stainless steel AISI 304 in solution of 0.5M H2SO4. The experiments were carried out on a technical stand with a model pair type pin-ondisc. The stand was...
RESEARCH OF THE ELEMENT SURFACE EXPOSED TO FRICTION IN THE BASE OIL BY POTENTIOMETRY
The protection of corrosion in mechanical devices and tribological properties of steel components, which are required, is achieved either through the immersion in the dielectric environment or through applying a grease l...
THE ANTIWEAR EFFECTIVENESS OF LUBRICANTS CONTAINING CHO-TYPE ADDITIVES
The aim of this study was to investigate the possibility of application of CHO-type substances, derived from rapeseed oil refining, as effective antiwear modifiers in lubricants. The study showed a dominant influence of...