The investigation of the corrosion resistance of the tension clamps Skl14
Journal Title: Materials Engineering - Materialove inzinierstvo (MEMI) - Year 2015, Vol 22, Issue 2
Abstract
At the level crossings it is possible to find the problems with the corrosion of the parts of the fastening system. These problems are especially at the rubber level crossings and in the tunnels. As a part of the thesis the problem of the corrosion of the tension clamp Skl14 of the producer Vossloh at the rubber level crossings is examined. For the purposes of the comparison the tension clamps without the corrosion protection and the tension clamps with the corrosion protection KTL were examined. As a first step the corrosion features of the tension clamps Skl14 were solved. The examination was divided into two parts. First part it was the examination according to ČSN EN ISO 9227. The samples of the tension clamps were putted into the corrosion chamber. After 1728 h the results of the corrosion impacts were not satisfied. It was decided for the second step of the examination. It was the immersion in an electrolyte solution. As a result of the paper the corrosion features of the tension clamps without the corrosion protection and with the corrosion protection are compared.
Authors and Affiliations
Marek Pětioký, Bohumil Culek, Andrea Kalendová, Miroslav Kohl
Keywords
Related Articles
- EP ID EP127359
- DOI -
- Views 119
- Downloads 0
CHANGES OF RHEOLOGICAL PARAMETERS OF POLYPROPYLENE AND POLYETHYLENE AFTER EXPOSURE IN ALIPHATIC n-HEXANE
Rheological properties of thermoplastic polymer materials before and after exposure to a chemical solution were evaluated using the frequency sweep test, which monitors changes in viscoelastic properties of polymers with...
EVALUATION OF THE FLOW ACCELERATED CORROSION OF COPPER PIPES
Corrosion behavior of the Cu pipe system has been investigated by long term experiment. The two identical experimental systems were made and fulfilled by the solution of 3 % NaCl. The work medium in the first system was...
Improvement of the wear behaviour of highly-loaded components and tools by multi-combined surface treatment
These multi-combined surface treatments lead to a significant improvement in load-supporting capacity. Critical load values of cohesive failure measured by scratch tests are tripled when compared to the individual treatm...
THERMAL STABILITY OF Al-Cu-Fe QUASICRYSTALS PREPARED BY SHS METHOD
Quasicrystal-containing materials are usually prepared by rapid solidification of the melt (e.g. by melt spinning) or mechanical alloying. In this work, the method using exothermic reactions between compressed metallic p...
EFFECT OF THE HEAT AND SURFACE LASER TREATMENT ON THE CORROSION DEGRADATION OF THE Mg-Al ALLOYS
In this paper there is presented the corrosion behaviour of the cast magnesium alloys as cast state, after heat and laser treatment. Pitting corrosion resistance of the analyzed alloys was carried out using the potentiod...