The Load Influence on the Diagnosis of the Three-Phase Rectifier by Using the Analytical Model Method
Journal Title: ANALELE UNIVERSITATII DIN CRAIOVA - Seria Inginerie electrica - Year 2014, Vol 38, Issue 38
Abstract
For the operation of the static power converters, the experience of an expert is absolutely necessary for competitive operation. Minor faults or defects of the elements of the static power converters can lead to ravaging effects both for the other components as well as other equipment from their operating system. The paper proposes a diagnosis method based on the analytic model which investigates the output waveforms of a three-phase rectifier supplying two types of loads: a passive RLC load and a variable DC drive. Two types of possible faults of the switches are considered: interrupted and short circuit. For identifying the defective components, the waveforms corresponding for different faults are stored in an information database in order to be compared with the ones corresponding to normal operation.. Another solved problem in this article refers to the influence’s analysis of the defect propagation in the driving system. There are analyzed the waveforms corresponding of the different faults for different types of loads including a passive RLC load and a variable DC drive. For the both types of faults, important oscillations of the output voltage of the static power converter are noticed which can damage the load, but also, determine the additional stress to other healthy switches.
Authors and Affiliations
Virginia IVANOV, Maria BROJBOIU, Sergiu IVANOV
Keywords
Related Articles
- EP ID EP158275
- DOI -
- Views 141
- Downloads 0
Rotor flux oriented control on the rotor side of the induction motor
In heavy duty drives, in the range of hundreds kW, wound rotor induction motors are widely used. It is the case of cement and minerals industries. Major users make use of tens of such drives, summing hundreds of MW. Due...
Supply voltage and resistant torque influence on dynamic characteristics of reluctance synhronous motors
The reluctance synchronous motors, as well as the synchronous permanent magnet motors, are the best solution from technical and economic point of view, for low and middle powers. This paper presents a series of simulatio...
Dynamic State of Low Power Asynchronous Motors in Direct-on-Line Starting
The research opportunity is explained by the results obtained in modelling and simulation of asynchronous motors, in the purpose of increasing their technical and economic performances when they operate in dynamic states...
INSULATION RESISTANCE TESTING OF THE MEDIUM VOLTAGE SWITCHES
This paper refers, in general, to the problem of off-line diagnosis of automated switches, and in particular it refers to the testing procedures regarding the insulation resistance. The factors that have a negative influ...
Comparisons Among p - Channel, n-Channel and Mixed n/p Channel OTFTs
Some theoretical approaches of an alternative organic semiconductor device are presented in this work. The Organic transistors are based either on n-type or p-type or mixed p/n overlapped layers. The carrier modulation i...