THE RESONANT OVERVOLTAGE IN NON-SINUSOIDAL MODE OF MAIN ELECTRIC NETWORK
Journal Title: Електротехніка і Електромеханіка - Year 2018, Vol 0, Issue 2
Abstract
Purpose. The resonant overvoltage arises in main electrical networks as a result of random coincidence of some parameters of circuit and its mode and it may exist for a relatively long time. Therefore, the traditional means of limitation of short duration commutation surges are not effective in this case. The study determines conditions of appearance and development of non-sinusoidal mode after switching idle autotransformer to the overhead line of extra high voltage. The purpose of the paper is to choice measures for prevention overvoltage, too. Methodology. The study has used the result of extra high voltage line testing, the methods of electric circuit theory and the simulation in the MATLAB & Simulink package. Results. The simulation model of the extra high voltage transmission line for the study of resonant non-sinusoidal overvoltage is developed. The conditions for the appearance of resonant circuits in the real power line are found and harmonic frequency in which overvoltage arises are obtained. The study proposes using the controlled switching device as a measure to prevent resonance surges and determines the appropriate settings. Originality. The expression for calculation of resonant length of extra high voltage line was derived. The special investigation of processes in the resonant circuit of the extra high voltage transmission line for higher harmonic components of voltage is carried out. The program of switching for control apparatus that prevents non-sinusoidal overvoltage has been developed at the first time. Practical value. The using of the proposed settings of controlled switchgear will prevent the occurrence of hazardous resonant surge on higher harmonic components of voltage.
Authors and Affiliations
V. G. Kuznetsov, Yu. I. Tugay, V. V. Kuchanskiy, Yu. G. Lyhovyd, V. A. Melnichuk
Keywords
Related Articles
- EP ID EP486252
- DOI 10.20998/2074-272X.2018.2.12
- Views 55
- Downloads 0
EXPERIMENTAL APPROBATION OF SHEET METAL MAGNETIC PERMEABILITY MEASUREMENT SYSTEMS
The article presents results of practical testing of measurement techniques and characterization of thin sheet metallic ferromagnets under real pulsed magnetic attraction of their sections specified by manufacturing oper...
MULTIOBJECTIVE SYNTHESIS OF ROBUST CONTROL BY MULTIMASS ELECTROMECHANICAL SYSTEMS BASED ON PARETO-OPTIMAL SOLUTION
A multiobjective method of synthesis of robust control of multimass electromechanical systems based on the construction of the Pareto-optimal solution is improved. A Pareto-optimal solution based on a stochastic multi-ag...
INVESTIGATION OF MECHANICAL STRESSES IN THE DRIVE SHAFT OF MV VACUUM CIRCUIT BREAKER
Introduction. In the last 10-15 years a dominant position in the market of medium voltage circuit breakers, vacuum circuit breakers have taken in which as an actuator mono- or bistable actuators with permanent magnets ar...
THE PROBLEM OF CORRECT CHOICE OF FERRITE BEADS
A ferrite bead is a passive electrical element used to suppress high-frequency noise in electric circuits. This is one of the simplest and the cheapest type of filters. Thus, such filters are widely used in electric and...
PLANAR SCHEMES TRACING IN THE SINGLE-LAYER CHANNEL
An algorithm for planar circuits tracing in a single layer channel, allowing more effective design solutions is proposed.