Theoretical rationale and identification of heat and mass transfer processes in vibration dryers with IR-energy supply
Journal Title: Восточно-Европейский журнал передовых технологий - Year 2018, Vol 4, Issue 8
Abstract
<p>The paper contains theoretical substantiation of the processes of radiation-convective heat and mass transfer between all the defining objects inside the vibration dryer with IR energy supply. The presented equations, developed on the basis of the heat and material balance, describe the basic dynamic characteristics of the drying mode for oil-bearing grain material in a continuously operating IR dryer.</p><p>Since there is no exact analytic solution of the presented mathematical model shaped as a system of differential equations with partial derivatives, the authors propose an approximate solution. The latter allows identifying the dependences between the distribution of temperature and moisture content of grain and oil-containing materials along the length of the dryer for any moment of time.</p><p>The numerical solution of the reduced mathematical model is possible only with the presence of certain interconnected kinetic coefficients. The kinetic coefficients can not be found experimentally by direct measurements; therefore, the article proposes a method to overcome these difficulties. The presented approximate analytical solution of the synthesized mathematical model, with the use of the method of inverse problems, has allowed determining sets of coefficients by the results of the experimental identification of dehydration. In the future, experimentally identified parametric complexes of the model can be used in the analysis of the drying process for approximate solutions or for further exact numerical solution.</p><p>Experimental studies of dehydration of grain material have proved that when the power of an IR source is increased from 400 to 500 W, the time for drying from the initial moisture content of 11 % to 8.75 % decreases from 9 to 7 minutes. It is determined that the Rebinder effect characterizing the dampness and thermal properties of the material decreases with a decrease in the moisture content from 0.04 at 11 % to 0.01 at 9 %. This is interesting from the practical point of view as the obtained results and the developed mathematical model can be used for increasing the energy efficiency of the processes of thermal drying in typical facilities that prepare oil-bearing grain materials for their processing.</p>
Authors and Affiliations
Valentyna Bandura, Roman Kalinichenko, Boris Kotov, Anatoly Spirin
Keywords
Related Articles
- EP ID EP528104
- DOI 10.15587/1729-4061.2018.139314
- Views 53
- Downloads 0
Studying the recurrent diagrams of carbon monoxide concentration at early ignitions in premises
<p class="a">It was shown that the methods of nonlinear dynamics, surpassing traditional methods of temporal, frequency or frequency-temporal analysis of dangerous ignition factors may be used for early detection of igni...
Development of a mathematical model for cost distribution of maintenance and repair of electrical equipment
The research is devoted to the development of a model for cost distribution of maintenance and repair of electrical equipment when making decisions on the management of the electric power system state. The decrease in th...
Analysis and optimization of the reactive power compensation modes in a power supply system
<p>The paper reports the study of modes in a single-phase generalized power supply system in terms of improving energy indicators in the system by compensating for the reactive power. We considered three test versions of...
Oxidation of 4brometylbenzene by ozone in acetic acid
<p>The kinetics and the mechanism of ozonation of 4-bromethylbenzene in acetic acid was studied. The constants of the rate of reaction of ozone with 4-bromethylbenzene and 4-bromacetophenone at different temperatures wer...
Exploring a possibility to control the stressedstrained state of cylinder liners in diesel engines by the tribotechnology of alignment
<p>Our research into the formation of a functional copper-containing surface layer on parts of automobile engines by using an alignment tribotechnology has established a decrease in the wear of parts during their operati...