Tribological Principles of Constructing the Reciprocating Machines
Journal Title: Tribology in Industry - Year 2015, Vol 37, Issue 1
Abstract
Reducing vehicle weight contributes to reducing fuel consumption and exhaust emissions. In practice, this is achieved by application of lightweight materials and through optimization of tribo-systems on the vehicle. The benefit of using aluminium is evident due to the reduced mass of the parts, but in parallel there is a problem due to the low strength of this metal. This is especially evident during overheating when can form cracks. The wear resistance and tribo-properties of aluminium are the problem, too. To achieve the strength and tribo-properties of aluminium alloys similar to grey cast iron, we applied eco-tribological knowledge during construction of reciprocating machines. The result of researches is patented prototype of aluminium piston and cylinder whose contact surfaces are coated or modified with inserts based on the tribo-materials.
Authors and Affiliations
S. Milojević , R. Pešić , D. Taranović
Keywords
Related Articles
- EP ID EP111247
- DOI -
- Views 101
- Downloads 0
Studies on Adhesive Wear Characteristics of Heat Treated Aluminium LM25/AlB2 Composites
The main aim of this study was to determine the adhesive wear characteristics of heat treated LM 25/AlB2 metal matrix composites fabricated using liquid metallurgy route. The composite samples were solutionized at 525 °C...
Tribological Studies of Antiwear Antifriction Composition and its Application
In recent decades appeared the considerable interest in the use of the antiwear, anticorrosion and restoration technologies in friction units, including the internal combustion engines. These technologies allow reducing...
Neutral Radius Value Determination by Numerical Simulation Method at Ring Upsetting Test
Ring upsetting represents a basic operation for bulk forming process and has particular significance since it is used for contact friction determination. At ring upsetting by flat dies, metal flow depends upon tribologic...
Study of Wear and Friction of Al-Fe Metal Matrix Composite Produced by Liquid Metallurgical Method
A modified impeller mixing coupled with chill casting technique was used for the preparation of Al-Fe composite. The electrolytic grade iron powder of 300mesh size was dispersed in the melt of commercially pure aluminum....
Effect of Nano Oil Additive Proportions on Friction and Wear Performance of Automotive Materials
The effect of nano boric acid and nano copper based engine and transmission oil additives in different volume ratios (1:10, 2:10, and 3:10) on friction and wear performance of cast iron and case carburized gear steel has...