TRIBOLOGICAL PROPERTIES OF COMPOSITE COATINGS ON ALUMINIUM ALLOY PARTS FOR TRANSPORT MEANS
Journal Title: Tribologia - Year 2017, Vol 272, Issue 2
Abstract
The present paper describes the structure, surface topography, and tribological properties of a DLC composite coating produced by magnetron sputtering on an engine cylinder liner AC-AlSi12NiCuMg (AC-47000) cast alloy as well as on AW-A6061 aluminium alloy matrix W6.A15A composite (AW-6061+10Al2O3P) used for the production of oil-less air compressor cylinders and car roof sliders. The DLC coating slid against a TG15 sliding composite under dry friction, which is an equivalent to the friction system for oil-less air compressors and against cast iron under limited lubrication conditions (boundary lubrication). The limited lubrication conditions are dominant during the starting of a cold combustion engine, when the viscosity of oil is too high and the splash lubrication is not sufficient. The DLC coatings’ properties are compared with the anodic hard coatings (AHC) and composite coating with an AHC matrix applied in sliding contacts presently used. The wear of composite TG15 during sliding against DLC was higher than during sliding against AHC. The DLC coating can replace the anodic hard coating and composite coatings on its matrix presently used in sliding contacts.
Authors and Affiliations
Andrzej POSMYK
Keywords
Related Articles
- EP ID EP240860
- DOI -
- Views 68
- Downloads 0
Właściwości tribologiczne anodowych warstw tlenkowych modyfikowanych cząstkami węgla i nanorurkami
STUDY ON THE USE OF CONTINUOUS MEASUREMENT OF CONSISTENCY TO IDENTIFY THE STRESS RELAXATION EFFECT IN THE MICROSTRUCTURE OF GREASES
The article discusses the construction of greases and shows the specific influence of intermolecular interaction on the stability of the microstructure of the grease composition. The paper deals with experimental studies...
THE IMPACT OF THE TYPE OF CUTTING FLUID ON THE TURNING PROCESS
This article compares the test results concerning the wear of cutting tools after face turning under dry friction conditions and lubricated friction conditions with biodegradable cutting fluid or mineral-oil based emulsi...
ANALYSIS OF HYDRODYNAMIC LUBRICATION OF JOURNAL BEARINGS WITH OIL OF NON-NEWTONIAN PROPERTIES
In this paper, the presented issue concerns hydrodynamic lubrication of the journal bearings with the oil of non-Newtonian properties. For the analysis of the hydrodynamic lubrication, a constitutive model of the third o...
Przebieg procesu zacierania smarowanych wysokoobciążonych skojarzeń ciernych z elementami pokrytymi powłoką WC/C
Celem pracy było opisanie mechanizmów niszczenia smarowanego wysokoobciążonego węzła tarcia z elementami pokrytymi niskotarciową powłoką WC/C tworzących strefę tarcia. Badania wykonano dla niskotarciowej powłoki WC/C (a-...