TRIBOLOGICAL PROPERTIES OF HYBRID LAYERS PRODUCED IN COMBINING THE DIFFUSION CHROMIZING PROCESS AND PVD TREATMENT
Journal Title: Tribologia - Year 2014, Vol 254, Issue 2
Abstract
Tribological properties of the CrC+CrN type hybrid layers, produced on X210Cr12 steel in chromizing process by the pack powder method combined with arc evaporation PVD treatment, have been investigated. A comparison of the CrC+CrN type hybrid layers with the CrC single carbide layers, produced on steel surface without CrN coating, has been performed. Tribological properties of the layers were performed by means of taper-three rolls test. It has been proved that the resistance to abrasive wear of hybrid CrC+CrN type layers is almost two times higher than that for the single CrC carbide layers.
Authors and Affiliations
Ewa KASPRZYCKA, Bogdan BOGDAŃSKI, Jan SENATORSKI, Piotr GĘBSKI
Keywords
Related Articles
- EP ID EP263712
- DOI -
- Views 42
- Downloads 0
The wear mechanism in heavy-loaded lubricated coated/steel sliding contacts
The wear mechanism of the coating/steel tribosystem compared with that for conventionally used steel/steel friction contacts under sliding conditions lubricated with base oil with various concentrations of extreme pressu...
WŁAŚCIWOŚCI TARCIOWE I ZUŻYCIOWE POWŁOK TLENKU GLINU WYTWARZANYCH METODĄ ZOL-ŻEL
Badane powłoki tlenku glinu zostały otrzymane w oparciu o metodę zol-żel z wykorzystaniem techniki zanurzeniowej (dip-coating). Na powierzchnie płytek krzemowych nanoszono roztwory prekursora, którym był sec-butoksyglin....
TRIBOLOGICAL PROPERTIES OF Al2O3 + TiO2 COATINGS MANUFACTURED BY PLASMA SPRAYING
In the paper the results of tribological, microscopic, and mechanical research of Al2O3 + TiO2 coatings manufactured by plasma spraying are presented. The feeding material was a powder Al2O3 + 13 wt.% TiO2 (Metco 6221, O...
MODELLING THE ACTUAL SURFACE COOPERATION DURING TURNING ACCOMPANYING THE DRY FRICTION PROCESS
The article presents the actual surface geometrical structure achieved during turning (in terms of 3D), which was converted into a CAD model. Such modelled surfaces of tribological nodes will undergo numerical simulation...
STANOWISKO DO BADANIA CIECZY MAGNETYCZNYCH PRACUJĄCYCH W TRYBIE ŚCISKANIA I ŚCINANIA
Zastosowanie cieczy magnetycznych w konstrukcji maszyn na skalę przemysłową jest faktem od ponad 20 lat. W szczególności ciecze magnetoreologiczne znalazły zastosowanie przede wszystkim w układach dyssypacji energii o st...