Two-mass Vibrating Conveyer with Nonparallel Flat Springs
Journal Title: Український журнал із машинобудування і матеріалознавства - Year 2016, Vol 2, Issue 1
Abstract
The analysis of operation of vibrating conveyers with nonparallel placement of flat springs is carried out. The motion of mechanical oscillating system is investigated. The structure of the supporting unit for flat springs fastening is propounded. This structure allows simplifying of setting-up of two-mass vibrating conveyers with the aim to ensure the effective operation. The models of conveyers with nonparallel placement of springs, providing the accurate calculations of rigidities and angles of flat springs inclinations, considerably simplify the structures of conveyers and their setting-up to ensure the prescribed angles of vibrations. The proposed structure of fastening of flat springs ends allows increasing of operation efficiency of the two-mass vibrating conveyer. Due to such setting-up of the equipment it is possible to compensate some of its theoretical and structural faults. On the basis of presented investigations, it is planned to develop the three-mass models of conveyers-separators with transporting of separated components in different directions.
Authors and Affiliations
Petro Koruniak, Iryna Nishchenko, Vladyslav Shenbor, Vitaliy Korendiy
Keywords
Related Articles
- EP ID EP200003
- DOI -
- Views 111
- Downloads 0
Optimization of Welding Modes for High-Strength Low-Alloy Domex 700 Steel
The microstructure and hardness of the weld joints of DOMEX 700 steel were investigated. As a result, the optimization of the parameters of robotic arc welding in the environment of protective gases was carried out takin...
Research of Influence of Oscillations of Tool-Part System on Roughness of Surface Layer during High-Speed Friction Strengthening
During the discontinued friction strengthening except of the high-speed friction the processes of high-frequency shock loadings appears in the tool-part contact zone. The vibrations occur in the machine elastic system. D...
Corrosion-mechanical resistance of arc-sprayed coatings made from cored powders
Result of investigations of resistance against corrosion and mechanical resistance of obtained by means of arc-spray metallization (with the use of cored wires) coatings are presented. The cored wires (CWs) enable us to...
Propagation of Elastic-Tough-Plastic Wave in a Rod of Ideally Plastic Material which Possesses the Property of Yield Delay
The great number of theoretical and experimental investigations indicate that it is necessary to consider plastic deformation of metals as a process which proceeds in certain time interval. However, in such approaches, c...
Investigation of the Influence of Machining Factors on the Workpiece Deformation Mode in the Chip-forming Zone by the Finite Element Method
The results of studies of the impact strength, temperature factors and parameters of cutting tool geometry on the formation of the stress-strain and thermodynamic state of surfaces with different types of engineering mat...