VARIANTS AND TRANSFORMATION OF STRUCTURES OF SINGLE PHASE TRANSFORMERS AND REACTORS WITH A WINDING MAGNETIC CORE
Journal Title: Вісник Кременчуцького національного університету імені Михайла Остроградського - Year 2017, Vol 1, Issue 103
Abstract
Purpose. To substantiate the technical solutions included in the production and based on the analysis of the ways of reduc- ing the mass indexes and the loss of active power of single-phase induction static devices with a twisted magnetic core. Methodology. For solving the tasks of the practical use of new technical decisions of active part of transformers, the ground of their advantages is needed. The method of optimizing comparative analysis at the observance of electr o- magnetic equivalence principle is chosen electromagnetic system (EMS). The identity of power, electromagnetic load and voltages of windings, and also installation and execution of compared EMS are corresponding to this pri n- ciple. Results. The basic technical decisions of the electromagnetic systems of single-phased transformers are anlysed. It is indicated that the existent twisted single-phased induction static devices do not satisfy in a sufficient degree to the requirements of compactness and reliability of electrical engineering and radio electronic devices. The improvement and increase of indexes of compactness of inductive static devices (ISDs) at the use of traditional methods and variants of "non-waste" technology of production of magnetic cores can be obtained on the basis of structural optimization of EMS with unconventional configurations and spatial position of rods, yokes and windings’ coils. Originality. Structural transformation of single-phased induction static devices with twisted magnetic core is considered for the first time with the purpose to reduce the resource-demanding and increase of reliability. Trans- formation of structures is based on using the combined twisted elements of trapezium-shapedsection of hexahedral- formed sections of rods. Thus the durability of isolation increases depending on the change of bend of coils’ turns in angular zones from 90° to 120°, and also the material capacity of windings decreases. Practical value. The offered decisions and method of structural optimization will give an opportunity to reduce the mass-dimension indexes and active-power losses of ISDs with twisted magnetic core for the systems of electrical equipment of different tech- nique. References - 9, figures - 4.
Authors and Affiliations
О. Sadovoy
Keywords
Related Articles
- EP ID EP659403
- DOI -
- Views 112
- Downloads 0
A MANUFACTURING METHOD OF THE STABILIZING WORKING OF DIES FOR THE PULSED STAMPING
Purpose. To development and select the method of the hardening-stabilizing treatment of the die mirror for the hydroexplosive stamping of thin sheet parts of a closed form. Methodology. The determination of new technolog...
IMPROVING THE COMPONENT ASSESSMENT AIRCRAFT NOISE FOR THE CASE OF ITS RADIATION IN THE BACK SECTOR
Purpose. To improve the aircraft noise directivity function, which is used in the simulation of aircraft noise levels, by determining approximations of this function to suit different types of aircraft engines. Methodol...
INFLUENCE OF ANISOTROPY, THERMAL SENSITIVITY AND HIGH-TEMPERATURE HEAT EXCHANGE ON THE THERMONALIZED STATE OF A QUILL CYLINDER
Purpose. To develop and approbate new approach to the decision of tasks of quasistatic thermoelasticity of anisotropic bodies, taking into account thermosensitivity of material and high-temperature heat exchange with the...
CONCEPTUAL APPROACHES TO TRAINING TRANSLATORS: ESSENCE AND TRAINING SYSTEMS (ON THE EXAMPLE OF THE USA, AUSTRIA, UKRAINE)
Purpose. To reveal conceptual approaches to the training of translators in the countries which are different in terms of the level of socio-economic relations development as well as in the systems of training translators...
KINEMATIC AND POWER PARAMETERS OF THE PROCESS OF THE THICK PLATES STIFFENERS FORMING
Purpose. To develop the experimental technique for evaluating the reliability of the calculation model of the elastic-plastic deformation of thick sheet parts with stiffening elements, determining the limiting parameters...