A Novel Design Process Model for Manufacturing Based on Reverse Engineering
Journal Title: Gazi Üniversitesi Fen Bilimleri Dergisi Part C: Tasarım ve Teknoloji - Year 2018, Vol 6, Issue 1
Abstract
Engineering can be classified into two groups as forward engineering (FE) and reverse engineering (RE). Forward engineering method progress from the definition of the problem to evaluation, test, and optimization of the solution. Besides, reverse engineering method progresses from examination and analysis of an existing solution thus enabling re-design, development, and manufacturing of the solution or a new solution. This study begins with a comprehensive literature review where reverse engineering methods are demonstrated. Furthermore, a new design method that also implements reverse engineering has been suggested. Suggested design process model for manufacturing can provide qualitative support for the designers to apply reverse engineering approach for their design works.
Authors and Affiliations
Tamer TÜRKÜCÜ, H. Rıza BÖRKLÜ
Keywords
Related Articles
- EP ID EP489641
- DOI 10.29109/http-gujsc-gazi-edu-tr.327479
- Views 96
- Downloads 0
The barrier height (BH) and ideality factor (n) distribution in identically prepared Al/ Bi3Ti4O12/n-Si (MFS) structures
In this study, the values of barrier heights and ideality factors of identically fabricated Au/BTO/n-Si (MFS) type SBDs (60 dots) have been obtained from their intercepts and slopes linear parts of forward bias lnI vs V...
Review of the Solid-State Transformers and an Application of Full Bridge DC/DC Converter
With the increased power to weight ratio, corresponding to the developments in material science, the demand for high frequency transformers (HFT) in air, land, marine and aerospace technologies where the weight is partic...
Design and Numerical Analysis of a Double-Tube Magnetorheological Shock Absorber for Vehicle Seat Suspension Systems
In scissors-type suspension mechanisms of the driver's seats of vehicles such as tractors, trucks and buses, conventional double-tube shock absorbers are often used as dampers due to the length of the course. The damping...
Investigation of Dry Friction Wear Behavior of Zinc-Aluminum (ZnA) Alloys Produced by Mechanical Alloying
ZA alloy powders having different compositions were prepared by mechanical alloying in a spex mill. The mechanical alloying was applied 5 to 8 h and the ball to powder weight ratio was kept at 10:1 by weight. The mechani...
Investigation of Design, Manufacturing and Performance of Light Metal Matrix Composite Material Production System
In this study, a production unit for light metal based particle reinforced composite material with stir casting technique was designed, manufactured and experiments related to performance have been carried out. In produc...