A Numerical Model for Estimation of Service Life of Tribological Systems of the Piston Engine
Journal Title: Tribology in Industry - Year 2017, Vol 39, Issue 3
Abstract
This article describes, develops and applies approach of the interaction of rough surfaces for one of the tasks of simulation of tribological systems of the piston engine. In this paper we described the general approach to building a model of interaction between rough surfaces, leading to the analysis of the Markov process. Given the initial data and the method of calculating the trajectory of movable elements on the lubricating layer, we determined the tribological parameters defining the service life of tribological systems of the piston engine on the example of crankshaft bearings.
Authors and Affiliations
K . Gavrilov, Y . Goritskiy, I . Migal, M . Izzatulloev
Keywords
Related Articles
- EP ID EP229715
- DOI 10.24874/ti.2017.39.03.07
- Views 120
- Downloads 0
Research Regarding the Anticorosiv Protection of Atmospheric andVacuum Distillation Unit that Process Crude Oil
Due to high boiling temperature, organic acids are present in the warmer areas of metal equipment from atmospheric and vacuum distillation units and determine, increased corrosion processes in furnace tubes, transfer lin...
A Historical Review of Gas Lubrication: From Reynolds to Active Compensations
Friction and wear are tribological phenomena that have produced significant economic damage and environmental issues throughout our history. Different kinds of lubricants and coatings have been employed in the attempt of...
Wear and Corrosion Resistance of CrN-based Coatings Deposited by R.F Magnetron Sputtering
A comparative study was conducted to evaluate the performances against wear and corrosion of CrN, CrMoN, CrZrN, CrVN single layer thin films. The latest are synthesized onto steel substrates (DIN 90CrMoV8), using R.F rea...
A Nanomechanical Approach on the Measurement of the Elastic Properties of Epoxy Reinforced Carbon Nanotube Nanocomposites
The mechanical behaviour of nanocomposite materials with multiwall carbon nanotube (MWCNT) reinforcements is investigated in the present paper. Epoxy nanocomposites with different weight percentages of carbon nanotubes h...
Fabrication of LM25/SiO2 Metal Matrix Composite and Optimization of Wear Process Parameters Using Design of Experiment
LM25 aluminium alloy reinforced with 15 wt% SiO2 metal matrix composite was fabricated by liquid metallurgy technique. Microstructure of the fabricated composite specimen was observed using inverted metallurgical microsc...