ACOUSTIC ENERGY AT CHANGE OF TREATED COMPOSITE MATERIAL DISPERSION PROPERTIES
Journal Title: Вісник Національного Авіаційного Університету - Year 2016, Vol 69, Issue 4
Abstract
Purpose: The aim of this study is to investigate the influence of treated composite material dispersion properties on acoustic radiation energy, which appears during composite material machining. Methods: The researches were grounded on simulation of acoustic radiation energy at change of mechanically treated composite material properties dispersion for the mechanical model of its surface layer destruction. The data processing with definition of acoustic radiation statistical energy parameters was conducted. The analysis of acoustic emission energy parameters sensitivity to change of composite material properties dispersion, and as the analysis of influencing of composite material properties dispersion on AE amplitude and energy parameters was conducted. Results: Were obtained that at decreasing of composite material properties dispersion there is increasing an average level of acoustic radiation energy and value of its deviation. Is determined, that at decreasing of composite material properties dispersion the greatest increasing there is an acoustic emission energy average level dispersion. It is show that the increasing of acoustic radiation energy parameters advances increasing its amplitude parameters. Discussion: The simulation of acoustic radiation energy at composite material machining for the mechanical model surface layer destruction at decreasing of composite material properties dispersion (spread) is conducted. It is shown, that the decreasing of composite material properties dispersion does not influence on acoustic radiation energy nature change. At the same time, the ascending parameter, that describing of composite material properties dispersion decreasing, results in increase of acoustic radiation signal energy parameters. The obtained outcomes can be used at mining methods of verification, diagnostic and monitoring of composite material machining technological processes. Thus during the composite material machining is possible to control and to determine of composite material properties rejection by analysis of acoustic emission signal energy average level dispersion.
Authors and Affiliations
Sergii Filonenko
Keywords
Related Articles
- EP ID EP460958
- DOI 10.18372/2306-1472.69.11055
- Views 118
- Downloads 0
A HUMAN RIGHTS APPROACH TO LIABILITY FOR SPACE DAMAGE
The purpose of the research: to identify the areas of optimization of legal regulation of liability for space damage on the basis of a comprehensive analysis of international acts and legislation of foreign countries....
APPLICATION OF IMPRECISE MODELS IN ANALYSIS OF RISK MANAGEMENT OF SOFTWARE SYSTEMS
The analysis of functional completeness for existing detection systems was conducted. It made it possible to define information systems with a similar feature set, to assess the degree of similarity and the matching degr...
THE ROCK-COAL BOUNDARY CONTROL METH ODS SUBSTANTIATION FOR COAL MINING COMBINES
The issue of diagnostics provided by modern methods is considered in this paper to control the rock-coal boundary that are based on the application of various sensors and approaches. A detailed analysis for the various...
RESEARCH AND MATHEMATICAL MODELING OF TURBULENT BOUNDARY LAYER AT POSITIVE PRESSURE GRADIENT
Purpose: Mathematical modeling of complex turbulent near-wall flows, that occur during the flow of airfoils, is impossible without understanding the nature of the flow in boundary layer. From...
OPTIMIZATION TASK OF NAVIGATIONAL AIDS GROUND NETWORK
Purpose: The represented research results are aimed to formulate an optimization task of ground based navigational aids network in order to improve performance of provided navigational service...