ADOPTION OF THE CRITERION OF OPTIMAL DESIGN SOLUTIONS WHILE DEVELOPMENT OF THE ENERGY SYSTEMS
Journal Title: Вчені записки Таврійського національного університету імені В. І. Вернадського. Серія: Технічні науки - Year 2018, Vol 29, Issue 3
Abstract
The paper presents the developed universal criterion of optimal design solutions (CODS) to be applied during development of new energy systems with the increased power output parameters from a system’s unit mass. An algorithm for calculating the criterion was developed and an example of its application was presented. The introduced criterion can be used in course of development of new energy systems of various types and industrial applications. Adoption of the introduced criterion at the preliminary design stage contributes to obtaining the fundamentally new, breakthrough solutions in design of the energy systems. Analysis of the criterion allows to determine the reserve of power characteristics which cannot be obtained while using the standard design solutions.
Authors and Affiliations
А. В. Кулалаев, В. В. Кулалаев
Keywords
Related Articles
- EP ID EP578640
- DOI -
- Views 57
- Downloads 0
APPLICATION OF B-SPLINES FOR DETERMINATION OF DEPENDENCE OF ISOBARIC HEAT CAPACITY OF AIR ON TEMPERATURE AND PRESSURE
The work is devoted to the development of the method of analytical representation of the specific isobaric heat capacity of air with the use of B-splines for the range of temperature and pressure variations typical for c...
STATE OF DEVELOPMENT OF AUTOMATED CONTROL SYSTEMS IN ELECTRICAL NETWORKS
The article discusses the main directions of development of automated control systems (ACS) of electrical networks, in particular, substations. The need to create such systems is determined by the complexity of the modes...
THE SYSTEM FOR CONTROL OF VVER-1000 FUEL PROPERTIES WHEN KEEPING THE COOLANT TEMPERATURE CONSTANT
The necessity of the development and introduction of the automated control system of nuclear fuel properties during the operation of the WWER-1000 type reactor with the constant average temperature of the heat carrier of...
IMPROVING THE PROPERTIES OF CONCRETE FOR 3D PRINTING
In work the analysis of used materials is carried out at 3D printing in construction. To increase productivity and ensure high quality 3D printing, it is necessary to use concrete with enhanced properties. It is proposed...
MEM ACCELEROMETERS PRODUCTION TECHNOLOGICAL PROCESS SIMULATION
On the article is proposed MEMS accelerometers production technological process simulation. The model will allow obtaining dynamic characteristics of the process and optimizing operations for improving the efficiency of...