Aloe vera as cutting fluid optimization using response surface method
Journal Title: Восточно-Европейский журнал передовых технологий - Year 2018, Vol 1, Issue 1
Abstract
<p>The fluid of vegetable Aloe Vera has characteristics as a cutting fluid, Aloe Vera cutting fluid (AVCF) has an excess of environmental reduction effects from oil-based cutting fluid (OBCF). Surface Response Methodology (RSM) based Central Composite Design (CCD) was applied as an experimental design, to predict the optimum parameters in the turning process. Because RSM is the final description of a good experimental design to improve the linear response surface model, and in determining the optimum operating conditions. Twenty sets of experimental tests were prepared by three reversed parameter factors, feed rate (f), depth of cut (a), and AVCF three type. Roughness (Ra) and flank wear (VB) were defined as response variables and then analyzed by multiple quadratic regression to determine the most appropriate mathematical model. The combined effects of the parameters were investigated using contour plots and surface plots. HSS as a cutting tool and Steel St.42 workpiece were used to achieve 20 tests. The adequacy of the developed model was examined using Analysis of Variance. Based on the results, the optimum process is shown by the following parameters: f=0.140 mm/rev; a=2.0556 mm, and AVCF=71.8970 cSt provide optimal cutting conditions with lower Ra and f=0.20 mm/rev, a=2.50 mm, and AVCF=8.8050 cSt giveoptimal cutting conditions with lower VB. Therefore, the improvement of AVCF as a substitute for OBCF continued experiments.</p>
Authors and Affiliations
Priyagung Hartono, Pratikto Pratikto, Agus Suprapto, Yudy Surya Irawan
Keywords
Related Articles
- EP ID EP527724
- DOI 10.15587/1729-4061.2018.123223
- Views 139
- Downloads 0
Development of a method for ranking factors that influence the maturity of project quality management processes
<p>According to the results of the theoretical analysis of well-known and widely practically applied standards of quality management and project management, as well as models of maturity assessment of processes, 13 key r...
Analysis of the preform blowing stage when obtaining a polymeric product using the extrusion blow molding method
<p>It was shown that the process of blowing a polymer preform has two characteristic stages. We obtained analytical dependences that link geometric parameters (diameter, wall thickness) of a molded polymeric preform and...
Analysis of probabilities of differentials for block cipher “Kalyna” (DSTU 7624:2014)
<p class="a"><span lang="EN-US">The adaptation and application of the method for estimating the upper bound of the probability of tworound differentials for the block symmetric cipher Kalyna is carried out. This cipher...
The study of lentil flour as a raw material for production of semismoked sausages
<p class="a">In the production of sausages, soy and products of its processing, varieties of food soy flour are mainly used as an additional component. It has been established in a study of safety of using soy that a lar...
Studying the effect of the combined technology on durability of the shafttype parts
<p>Restoration of shaft parts with extending their service life is an important reserve of development and growth of repair efficiency. Improvement of wear resistance and durability of parts of agricultural machinery is...