An attempt of assessing the production perspectives concerning malleable iron castings
Journal Title: Archiwum Odlewnictwa - Year 2009, Vol 9, Issue 3
Abstract
The paper presents a historical outline of production of the malleable cast iron castings on the territory of Poland during the past over a hundred years. There have been also gathered data concerning the total quantity of castings and the quantity of malleable iron and nodular iron castings produced in twelve selected countries over the period from 1993 to 2006. The percentage of malleable iron to total production of castings, and for a purpose of comparison the percentage of nodular cast iron to total production of castings, has been determined for these countries. A distinct decreasing tendency can be seen with respect to the production of malleable iron castings, while an increasing trend exists in production of nodular iron castings.
Authors and Affiliations
M. S. Soiński, D. Trepka, K. Lewandowski
Keywords
Related Articles
- EP ID EP72028
- DOI -
- Views 89
- Downloads 0
The structure of Ni–enriched Al–Ni molten alloy before solidification
The structure of Ni–based molten alloy, containing 88,02w.%Ni and dopped both with Zr (0,46w.%) and B (0,02w.%) has been studied by means of X–ray diffraction method at temperature 1500 K. Structure factor and pair corre...
Evaluation of Synthetic Gypsum Recovered via Wet Flue-Gas Desulfurization from Electric Power Plants for Use in Foundries
This article investigates possible use of waste gypsum (synthetic), recovered via flue-gas desulfurization from coal-fired electric power plants, in foundries. Energy sector, which in Eastern Europe is mostly composed fr...
The influence of amperage of electric arc on microhardness in the area single and overlapping remeltings of HS 6-5-2 steel
The present thesis depicts the microhardness of HV0,065 surface layer of high speed steel HS6-5-2 remelted with the electric arc. There were different surface layer variants of remelting used – the amperage was changed f...
Thermal aspects of temperature transformations in silica sand
Problems related with the choice of moulding sand composition considering its behaviour in contact with molten metal were discussed. The investigations of high-temperature phenomena enable moulding sand composition to be...
Reclaimability of the spent sand mixture – sand with bentonite – sand with furfuryl resin
Introduction of new binding materials and new technologies of their hardening in casting moulds and cores production requires the application of reclamation methods adequate to their properties as well as special devices...