An imaging-based detection device for on-line products inspection
Journal Title: Science Paper Online - Year 2008, Vol 3, Issue 1
Abstract
The image of product in question is acquired by CMOS image sensor and thus is digitized and transferred to MCU. The quality of the product is evaluated through image processing and analyzed by ARM. In so doing, the defective products are automatically removed by the proposed system, with the inspection results gathered and reported to supervising computer on a daily basis. The system adopts LPC2210 processor featured in ARM7TDMI, along with the imbedded multi-task real-time μC/OS-Ⅱoperating system. The presented system simplifies the development of application software, as well as ensures real-time running and reliability for each task, thus the performance of design is satisfied.
Authors and Affiliations
ZHENG Kerong ZHU Shuangdong
Keywords
Related Articles
- EP ID EP84237
- DOI -
- Views 103
- Downloads 0
Interface of SiCf／Ti-matrix composites
SiC fiber reinforced Ti-matrix composites are important materials for the application in aerospace. However, the interfacial reaction between fiber and matrix degenerates the mechanical properties of the composites. With...
Research on the Self-healing of Cementitious Calillary Crystalline Waterproofing Material
The crack and leakage is always stubborn disease in concrete structure. Using water as its carrier cementitious calillary crystalline waterproofing material (i.e. CCCW) can be transmitted in the capillaries of concrete b...
雾状油膜水滴冷却润滑加工法对车削的影响
油膜水滴是使用冷空气、微量可自然降解油剂和少量水，经复合喷雾法形成可自然分解的、新型绿色切削液。本文阐述了雾状油膜水滴冷却润滑原理和方法,并通过车削试验，比较和分析了不同冷却润滑加工方法下刀具磨损和已加工表面质量，揭示出...
大孔径多孔氧化铝膜的制备
本文使用磷酸和草酸的混合溶液为电解液，在90 V电压下，控制电解液温度在5～10℃制备了平均孔径高达200 nm，开孔密度为1.7×109 pores/cm2的多孔阳极氧化铝(AAO)膜。与使用单一酸为电解质相比，使用混合酸制备大孔径氧化铝膜所需的电压较低...
钨基MIM喂料能量相互作用与流变学研究
本文建立起在金属粉末注射成形喂料中粉末-聚合物相互作用能关系模型。通过引入点阵模拟，提出了为达到体系能量平衡，颗粒尺寸及粉末浓度的选择准则。结合W-PW-HDPE分散系的理论分析和实验观察，提出了适用于这种体系的具体的颗粒尺寸和粉...