ANALYSIS INTO THE INFLUENCE OF SELECTED TOOTHED GEAR PARAMETERS ON THE VALUE OF SLIPPAGE AND CONTACT STRESSES IN A CYLINDRICAL GEARBOX
Journal Title: Tribologia - Year 2018, Vol 280, Issue 4
Abstract
The paper presents issues concerning the geometrical and durability calculations of power shift gearboxes with multi-criterion optimization, using proprietary computer software. Among many parameters influencing the value of slippage and contact stresses, the flank ratio at P-0 correction and P correction, the value of the flank angle, and the module value were analysed. The slippage was analysed at Point B1, which belongs to the beginning of the single tooth engagement area, as well as in Point B2, where the single tooth engagement area ends. Contact stresses were calculated at Point C, which is the pitch point. Their values were referenced to experimentally determined fatigue contact durability σHlim.<br/><br/>
Authors and Affiliations
Marek MARTYNA, Jan ZWOLAK
ANALYSIS OF CONTACT AND BENDING STRESSES IN GEARBOX SWITCHING UNDER LOAD
The work analyses contact stresses that occur within the active surface of toothed gears as well as bending stresses that take place at the tooth root. Contact stresses have been designated at the beginning of the single...
EFFECTS OF FRICTION ON THE SEWING WORK AND ON THE EFFICIENCY OF SEWING PROCESS OF FOOTWEAR ELEMENTS
The influence of the structure of ethoxylated fatty alcohol alkyl chain on physical-chemical and tribological properties of their aqueous solutions is analysed in the paper. Aqueous solutions of mixtures of two alcohols,...
DETERMINATION OF LUBRICITY PROPERTIES OF HYDROCRACKED DIESEL BASE FUEL AS THE FUNCTION OF THE CONCENTRATION OF CHO ADDITIVES PART IV
Part 1 of the investigated subject field contains the initial methodical results. Part 2 generally describes basis of the thematic area: findings of the tribological proprieties of ester additives CHO (carbon, hydrogen,...
INFLUENCE OF THE DISPERGATION CONDITIONS OF MONTMORYLONITE IN EPOXY RESIN ON THE MECHANICAL PROPERTIES AND MORPHOLOGY OF NANOCOMPOSITES
The paper presents of the investigation of mechanical properties and morphology of epoxy matrix nanocomposites. Montmorylonite (MMT) Closite 30B was used as aluminosilicate nanofiller. It has been found that presence of...
CHARACTERIZATION OF MULTICOMPONENT, TRIBOLOGICAL AlCrTiN COATINGS, PRODUCED BY THE FILTERED CATHODIC VACUUM ARC METHOD
In this paper, the AlCrTiN coatings deposited by the cathodic arc method using a plasma filtration system have been studied to determine the effect of the use of this technology on the structural, mechanical, and tribolo...