ANALYSIS OF ELECTROMAGNETIC PROCESS IN COMBINED INDUCTOR SYSTEMS, AS TOOLS FOR STRAIGHTENING OF MODERN CAR
Journal Title: Електротехніка і Електромеханіка - Year 2015, Vol 0, Issue 4
Abstract
The field in combined inductor systems exists only over workpiece, it occurs at only a low-frequency circular magnetic field. In this paper electromagnetic processes in tools of the magnetic pulse attraction (the combined inductor systems) are analyzed. Investigation based on numerical estimations, using previously obtained analytical relations for the excited fields and forces. Calculations are necessary for the successful implementation of straightening metal coatings bodies car. A distribution of relative intensity of magnetic fields to surfaces of sheet workpiece in the centre of a working zone is obtained. The distribution of amplitude tangential component intensity of resulting magnetic field of the surface of sheet metal along the centre of a rectangular coil is received. Feature of the combined induction system is non-uniformly distributed forces of attraction in the work area. The results showed that the calculated working area on the outer surface of sheet workpiece magnetic field strength will be less than 5% of the field strength of a circular low-frequency source. Calculations have shown the effectiveness of the proposed instrument magnetic pulse straightening metal coating bodies car. The actual amplitude of distributed attraction forces are ~ 7.7 MPa.
Authors and Affiliations
D. O. Voloncevich, M. V. Barbashova, O. S. Sabokar
Keywords
Related Articles
- EP ID EP301310
- DOI 10.20998/2074-272X.2015.4.09
- Views 69
- Downloads 0
DEVELOPMENT AND INVESTIGATION OF LAYOUT OF ACTIVE SCREENING SYSTEM OF THE MAGNETIC FIELD GENERATED BY GROUP OF OVERHEAD TRANSMISSION LINES
Purpose. Development and field experimental research of layout of the single-circuit active screening system of the magnetic field generated by group of high voltage transmission lines in residential area is given. Metho...
ANALYSIS OF ELECTROMAGNETIC PROCESSES IN THE SYSTEM «CYLINDRICAL SOLENOID – MASSIVE CONDUCTOR»
Purpose. Defining the key parameters of the inductor geometry, as a long multi-turn solenoid, that influence on the current amplitude induced excited in a massive conductor with a flat boundary surface. Methodology. Perf...
A 2-POLE WINDING DEVELOPMENT TECHNIQUE FOR ASYNCHRONOUS MACHINES WITH INCREASED NUMBER OF PARALLEL BRANCHES
A 2-pole winding development technique is introduced for asynchronous machines with the number of parallel branches in phases increased in 1.5 and 2 times as compared with the number of poles. The technique is confirmed...
AN ANTHOLOGY OF THE DISTINGUISHED ACHIEVEMENTS IN SCIENCE AND TECHNIQUE. PART 43: TRADITIONAL POWER ENGINEERING. THERMAL POWER PLANTS: STATE AND PROSPECTS OF THEIR DEVELOPMENT
Purpose. Preparation of brief scientific and technical review with an analytical analysis about the state, achievements, problems and prospects of development of world thermal power engineering. Methodology. Known scient...
LIMITATIONS OF CURRENT OF THE THREE-PHASE ACTIVE POWER FILTER IN THE CONDITIONS OF OVERLOAD AND SHORT CIRCUIT
Purpose. The purpose of the work is to develop a method of limiting the maximum allowable level of current of a three-phase active power filter in conditions of overload or short circuit and a system for the implementati...