Аnalysis of operating modes of singlephase currentsource rectifier with rectangularstepped pulsewidth modulation
Journal Title: Восточно-Европейский журнал передовых технологий - Year 2018, Vol 3, Issue 9
Abstract
<p>The operating modes of the single-phase active current-source rectifier in the case of rectangular-stepped pulse-width modulation and load in the form of DC traction motor are investigated. The single-phase bridge rectifier circuit with a discharge diode is considered. The mathematical model of the rectifier is developed and the main ratios for pulse-width modulation with rectangular-stepped modulating signal are determined. On the computer model, electromagnetic processes at three modulation frequencies (900, 1,200, 1,800 Hz) are studied. The features of the effect of the modulation depth and frequency on the rectifier power factor and the total harmonic voltage and current distortion in the mains supply are determined.</p><p>The DC motor for today remains the main type of the traction motor of the 25 kV, 50 Hz AC mainline electric locomotives of alternating current in Ukraine and in some other countries. To power such motors, diode or thyristor rectifiers are used. At the same time, it is known that converters on fully controlled semiconductor devices provide higher power efficiency.</p><p>The studies allow determining what values of modulation frequency and depth provide a high power factor (more than 0.9) and minimum total harmonic voltage and current distortion distortions in the mains supply. This allows finding rational approaches to the selection of power circuits and control algorithms for active converters in the traction electric drive of electric locomotives. The efficiency of increasing the power factor and reducing the total harmonic voltage and current distortion can be achieved, first of all, by reducing the power consumption for traction of trains.</p><p>According to the set of selected comparison criteria, the active current-source rectifier with a modulation frequency of 1,200 Hz is the most suitable for implementation in the traction electric drive of the electric locomotive. Provision of high power characteristics in a wide range of traction loads can be achieved in the multi-zone circuit of such a converter.</p>
Authors and Affiliations
Alexey Krasnov, Borys Liubarskyi, Vladimir Bozhko, Оleksandr Petrenko, Oksana Dubinina, Ramil Nuriiev
Improvement of efficiency in the organization of transfer trains at developed railway nodes by implementing a "flexible model"
<p>We have studied the efficiency of organization of transfer trains at developed railroad junctions based on the criterion of total hours of railroad wagon downtime under accumulation. We have constructed discrete-event...
Research into the process of multi-level management of enterprise production activities with taking risks into consideration
<p>The study considers the process of management of the production activity of an enterprise during a certain interval of time. It takes into account components of the production process and an influence of various produ...
Revealing special features of hydrodynamics in a rotor-disk film vaporizing plant
This paper reports the generalized results of computer simulation of physical processes at a rotor-disk film evaporating plant. Optimization of the operation mode cannot be achieved without establishing patterns in the c...
Metrological traceability of impedance parameter measurements in Ukraine
<p class="a"><span lang="EN-US">The equivalence rates of the national standard of a unit of electrical capacitance for denominations of 10 pF and 100 pF at frequencies of 1 kHz and 1.592 kHz and expanded uncertainties ob...
Effect of mechanoactivated chemical additives on the process of gas hydrate formation
<p>This study addresses the production of gas hydrate of methane with a high gas-hydrate-forming content in a solid phase in the isolated system at T=274 K and pressure of 5 MPa and presence of mechanically activated roc...