Analysis of self-oscillations of the wheeled vehicle model when driving on a straight-line segment of the overpass
Journal Title: Вісник Житомирського державного технологічного університету. Серія: Технічні науки - Year 2016, Vol 76, Issue 1
Abstract
There is the problem of traffic congestion of large cities of Ukraine. The introduction of the monorail will solve this problem. To ensure the comfort and safety of the transport of passengers it is proposed to investigate the lateral stability of this type of transportation, namely, to consider the question of self-oscillations. An approximate analysis of the amplitudes of oscillation of the model "one-wheeled" vehicle when driving on a straight-line segment of the overpass was performed. The diagram of the amplitudes of the oscillation system, which is received when changing the longitudinal speed of the crew allows us to estimate the influence of structural parameters of the system on the boundary of oscillatory instability and the amplitude of oscillation occurring. Rational selection of parameters of the transverse stiffness of the guide wheel module according to this method is consistent with the previously obtained research results. On the basis of the offered analytically-numerical method it is proved that rational choice of design parameters of systems that enable sustainable movement in the range operating speed (the maximum constructional speed of V = 140 km/h), moreover, security buckling when exceeding this speed. The amplitude of oscillation in excess of a critical value of the velocity parameter increases monotonically and does not exceed 3°, with V = 280 km/h
Authors and Affiliations
V. P. Sakhno, А. N. Yefymenko
Keywords
Related Articles
- EP ID EP254089
- DOI -
- Views 89
- Downloads 0
The device for the testing of the fragile rock samples within triaxial stress
The rocks at the depth are in volumetric stress (undergo an action, as a rule, a comprehensive compression). Comprehensive compression at the point of the array is characterized by a tensor of stresses acting on three mu...
Synthesis of a quasi-optimal regulator of conveyor load of a mining company using the concept of the Pearson method
The use of conveyor loading control systems allows to ensure maximum energy efficiency of equipment operation. At the same time, the presence in the control loop of a link of pure delay and non-linear expression on state...
Approaches to resource assessment of technical objects and systems
The problem of ensuring reliable operation of technical objects is becoming increasingly important, as the aging of equipment and structures causes an accumulation of damage, the development of defects, irreversible chan...
Effect of the tangent of the cutting blade on the performance of machining
The kinematic schemes of turning with a blade tool with tangential displacement of the cutting blade are considered. Methods are shown for reducing the tension of the cutting process due to interruption and periodization...
Improving the effectiveness of detailed processing by dynamic control of processing with high sports range
In this article the possibility of increasing the efficiency of the processing of parts with a diameter of up to 20 mm is analyzed, namely: vibration resistance of the cutting process at pinching due to cutting speed con...