ANALYSIS OF VIBRATION DETECTION USING ACTIVE CONTROLLER IN THE SMART CANTILEVER COMPOSITE BEAM WITH LQR AND FUZZY TECHNIQUES
Journal Title: International Journal of Mechanical and Production Engineering Research and Development (IJMPERD ) - Year 2018, Vol 8, Issue 4
Abstract
Vibration is the major problem in light weight composite structures. Active vibration methods are effective to control the vibration. In this work, vibration control using active controller for an E-Glass/Epoxy Cyanate laminated composite beam, which uses patches of piezoelectric ceramic patches as smart sensors and actuators were tested and analyzed. The combination of Linear Quadratic Regulator (LQR) with Kalman filter and Fuzzy technique gives greater Region Of Convergence (ROC). The control is based on the proximity output and the previous output. This combination gives best optimization in the output, hence the settling time is good, and the system gives fast and stable output response. The entire Vibration Reduction System (VRS) consists of a Data Acquisition module, composite beam with Piezo electric ceramic sensor and actuator. This VRS setup is simulated using Matlab/Simulink and the output analysis shows that, this system reduces the vibration efficiently compared to the previous methods.
Authors and Affiliations
FREDRICK GNANARAJ1 F, VIJAYA KUMAR K. R
Keywords
Related Articles
- EP ID EP430408
- DOI 10.24247/ijmperdoct20189
- Views 82
- Downloads 0
A Methodology and estimation of Film Thickness in Elastohydrodynamic Lubrication
Cam and tappetare always under gigantic stresses which lead to wear and tear of the same. Hence it must be identified, estimated and minimized for prolonged and smooth running of engine. This paper describes an approach...
Stepper Motor Actuator for HVAC Blend Door – A Review
duct has the heater core mounted on the evaporator core. The temperature of the air depends on the amount of mixing of the air, which passes through the heating core and then through the evaporator. The passage of air th...
DESIGN A POSITIONAL ERRORS CORRECTION, FOR ROBOT USING DIFFERENTIAL LOAD CELL TRANSFORMER FEED BACK ABDUL GAFFER .S .M, SATAR HABIB MNAATHR & KADIM KARIM MOHSEN
This paper describes a method for reducing the positioning errors of a robot during a given trajectory by using differential load cell transformer feedback to minimize the mean positioning error of the end-effector along...
The Effect of Ambient Temperature on Human Strength
Impact of environmental conditions like temperature is usually not considered in the measurement of work content analysis. However, to ensure healthy work conditions, it is imperative that studies on the effects of heat...
An Optimization and Investigation of Mechanical Properties and Microstructures on Friction Stir Welding of Aluminium Alloys
Now a day for industrial applications and automotive industries, many are utilizing advanced welding technique is Friction stir welding process, offering more advantages are quality of the weld is good, consumption power...