Stepper Motor Actuator for HVAC Blend Door – A Review
Journal Title: International Journal of Mechanical and Production Engineering Research and Development (IJMPERD ) - Year 2019, Vol 9, Issue 4
Abstract
duct has the heater core mounted on the evaporator core. The temperature of the air depends on the amount of mixing of the air, which passes through the heating core and then through the evaporator. The passage of air through the heater core is controlled by a flap which directs the air. In a conventional air conditioning and heating system in the car, the movement of the flap is manually. The passenger inside the vehicle adjust the flap according to their comfort. Heating, ventilation, and air conditioning (HVAC) is a type of technology which are being used extensively in vehicles, residential structures and office buildings for the environmental comfort of the human. HVAC mainly gives temperature comfort. This system also provides better indoor air. In the case of an automobile HVAC system it has all the same components which are similar to a conventional air conditioning and heating system. Only difference, the movement of the blend door are with the help of an actuator. The actuator would move the blend door constantly to mix the air between the hot air from the heating core and cold air from the evaporator to maintain the air temperature. Generally, in an HVAC door blend actuator, electro mechanical actuator is used. Electro mechanical actuator can be used in many places as they can generate motion which are mainly required by different valve actuation. The paper reviews about stepper motor being used in the actuator.
Authors and Affiliations
Adhirath Mandal, HaengMuk Cho
Keywords
Related Articles
- EP ID EP655628
- DOI 10.24247/ijmperdaug201934
- Views 79
- Downloads 0
Experimental Investigation on Corrosion Behaviour of Hot Upset P/M Plain Carbon Steel
The experimental work endeavors to examine the mechanism behind the corrosion phenomenon of sintered-hot upset plain carbon steel under induced corrosion acid pickling condition. The alloy powder mix of Fe-0.5%C was comp...
Improving the Impact Strength of Polymer Matrix Composite through the Additions of Different Additive
The main objective of this research is to improve the impact strength of polymer matrix composite. This was carried out by using several additives which are Fe particles, Al particles and sawdust particle with different...
Tip Leakage Effects on Flow Field of a Centrifugal Compressor
Tip leakage effects on the flow field of a low speed centrifugal compressor is observed computationally using structured multi block grid with fine grid in the tip leakage region. The computational study of centrifugal c...
The Behaviour of A Compression Ignition Engine Under the Influence of Diesel and Microalgae Biodiesel Blends
In the days to come Algae is going to be everything. Wonders would be created using algae. Scientists predict that, from the oxygen that we inhale to the electricity that we use, algae would be the source of energy in th...
A Study on the Effects of Heat Treatment on the Mechanical Properties of Aluminium Alloy (ADC 12) Reinforced With Iron Oxide (FE2O3)
The mechanical properties of an Al–Si–Cu alloy (ADC12) reinforced with iron oxide, produced using different Heat treatment to process is examined experimentally. Experimental studies were carried out for ADC 12, ADC 12 +...